Yarisworld Archive

12V supply

9 posts · 5,724 views

mezcarOriginal postUK · Feb 17, 2014#1
Hi folks,

I have a 2012 Yaris (UK spec)

I need 2 12v 1Amp switched supplies for 2 dash cams - one up front, the other in the rear. Please suggest where I can tap the power from? I have a USB in the glove box which currently the ipod is connected to. Thanks

Replies 8

CTScottUSA, CT · Feb 17, 2014#2
Do you have a normal key or the smart entry system?
mezcarThread starterUK · Feb 17, 2014#3
Norma key. it's a TR spec with touch and go. I was considering tapping the wire leading to the USB connector for the front. I don't mind rnning some power cabling from the front to the back, but if there was a ready 12V switched supply in the boot (trunk) area, it'd save on wiring.

Also, just out of interest, what is the maximum current available at the USB? The actual dash cams need 5V at 1amp, if I can use a 3 way USB splitter that would save on splicing power cables - 2xUSB for the dash cams and 1Xfor the iPod
CTScottUSA, CT · Feb 17, 2014#4
Originally Posted by mezcar ↑
Norma key. it's a TR spec with touch and go. I was considering tapping the wire leading to the USB connector for the front. I don't mind rnning some power cabling from the front to the back, but if there was a ready 12V switched supply in the boot (trunk) area, it'd save on wiring.

Also, just out of interest, what is the maximum current available at the USB? The actual dash cams need 5V at 1amp, if I can use a 3 way USB splitter that would save on splicing power cables - 2xUSB for the dash cams and 1Xfor the iPod
I doubt that the USB port can source much more than 1A.

On the front end your best source for 12 Volt switched power is the pink wire on the ignition switch connector. That circuit has at least 5A of available power feed.

At the boot, there unfortunately isn't an ignition switched power source.
mezcarThread starterUK · Feb 17, 2014#5
could i tap the power from the rear of the cigarette lighter? connect 2x female sockets from there?

thanks for your quick response
mezcarThread starterUK · Feb 17, 2014#6
how would i access the pink wire if that is my only option?
CTScottUSA, CT · Feb 17, 2014#7
The lighter power feed would be fine as well.

For the ignition switch you have to remove the lower steering column cover. There are two screws that you expose by turning the steering wheel in one direction and then the other and a third down by the tilt lever.
mezcarThread starterUK · Feb 18, 2014#8
Really appreciate your help. Thank you so much. What is the best way to access the lighter power feed?
CTScottUSA, CT · Feb 18, 2014#9
Originally Posted by mezcar ↑
Really appreciate your help. Thank you so much. What is the best way to access the lighter power feed?
You should be able to get to it by removing the radio. See the thread below for a good DIY on getting the radio out:

DIY: 2012 Radio Removal