Tools Needed:
1.Kung Fu Grip
2.8mm Socket, Extension, and Ratchet(I Used 8mm Screw Driver)
or Philips #2 Screw driver
Step 1.
Starting on the right side of vehicle(Passenger side USDM) pull the surround panel using your kung fu grip by the a/c vent. It is held in by clips all the way around. After you loosen the first clip just pull gently all the way around.
Picture not included in this copy
Step 2.
Pull the surround out around the radio. Held in by clips similar to the dash panel.
Picture not included in this copy
Step 3. (Optional)
Remove the connector for Hazard Switch. (I left it connected and let it hang)
Picture not included in this copy
Step 4.
Unscrew the Radio using your tool of choice.(Yellow dots, 2 screws on each side)
Picture not included in this copy
Picture not included in this copy
Step 5.
Pull the radio out and remove connectors.
Picture not included in this copy
🤘
1.Kung Fu Grip
2.8mm Socket, Extension, and Ratchet(I Used 8mm Screw Driver)
or Philips #2 Screw driver
Step 1.
Starting on the right side of vehicle(Passenger side USDM) pull the surround panel using your kung fu grip by the a/c vent. It is held in by clips all the way around. After you loosen the first clip just pull gently all the way around.
Picture not included in this copy
Step 2.
Pull the surround out around the radio. Held in by clips similar to the dash panel.
Picture not included in this copy
Step 3. (Optional)
Remove the connector for Hazard Switch. (I left it connected and let it hang)
Picture not included in this copy
Step 4.
Unscrew the Radio using your tool of choice.(Yellow dots, 2 screws on each side)
Picture not included in this copy
Picture not included in this copy
Step 5.
Pull the radio out and remove connectors.
Picture not included in this copy
🤘