Replies continued
yariSB86Thread starterOH · May 1, 2013#101Yeahs, thanks man. I'm picking some up Friday.
Think I got car to run pretty good. Still having issues with it stalling after lifting off throttle after a load. It's like when I lift off the rpms should go to 950-1100 like they do at idle but they keep falling until stall. My buddy was thinking adjusting the throttle position or changing the VE table. Any suggestions?
^^ my suggestion is you check that blow off valve and make sure its closing.
yariSB86Thread starterOH · May 2, 2013#103@kou - am i correct in thinking that if the BOV needs to be adjusted, it is done by removing that screw cap on the end?
Focus_Sh1ftNew Jersey · May 2, 2013#104^ Yes. I actually had to loosen mine to get it working better, but try tightening it and see if that solves any of your problems.
yariSB86Thread starterOH · May 2, 2013#105Thanks guys, ill give it a shot.
yariSB86Thread starterOH · May 2, 2013#106Update: As mentioned earlier I checked my BOV, I checked the spring and messed with it a bit, I didn't really change anything. I hooked it up to a cummins radiator cap pressure tester. it actually worked well. I plan on upgraded the BOV later down the line anyway.
I decided to start a fresh tune to see if I can get it to idle like stock. think I got pretty close. I don't know why my rpms are still kinda surging, not nearly as much as before but they do like 250ish. you'll see in the videos im about to post. with this tune I test drove it down the street (not included in the video) and I had a bunch of misfires. My buddy sitting next to me with my computer hooked up the the fic was able to retard the timing live and we fixed all misfires. over all im pretty happy that I got it running well. I'm still going to get it professionally tuned here next week. it will be interesting to see what happens and what the dyno reads :)
so with out further a due.
Before I leaned it out:
https://www.youtube.com/watch?v=EETj1jC8MIA After I leaned it:
https://www.youtube.com/watch?v=SDIYLWHa3pk Little bit o boost:
https://www.youtube.com/watch?v=70fq_fzEbZc yariSB86Thread starterOH · May 5, 2013#107so the local temp got warmer than when I originally tuned. so im misfiring and stalling again. time to adjust the maf map and retard some timing I think.
yariSB86Thread starterOH · May 23, 2013#108Update time:
I have an 08 ecu en route to replace my old 07.
I had a custom exhaust made. I'll show video of my old setup, then of the new.
Old setup New setup yariSB86Thread starterOH · May 23, 2013#109A few pics of the install.
Picture not included in this copy
Picture not included in this copy