Yarisworld Archive

Tools to change front and rear suspension

9 posts · 5,419 views

yariseggvvtiOriginal postCali · Jan 2, 2013#1
Can someone list the size of tools in order change front and rear suspension. Also, take off stock shock attachments in to Tein.

Very appreciated your help and information!

Happy New Year!👍

Replies 8

yPod09Santa Rosa, CA · Jan 3, 2013#2
Check out the DO IT YOURSELF section of the forum, TONS of helpful stuff.

Like the link below that has exactly what you are looking for:
TANABE DF210 Spring Install [pics]
yariseggvvtiThread starterCali · Jan 4, 2013#3
YPod09, Thanks for the link! I am going to try install the Tein basic this weekend.
CrankyOldManWest Michigan · Jan 4, 2013#4
If you are keeping the stock shocks, you MUST have the spring compressors to safely remove the spring retaining plates. You should also have access to a decent quality impact wrench, an 18" or longer breaker bar, and all of the tools listed in the guide/service manual.

Also, a decent set of jackstands is the bare minimum you need to safely lift the vehicle. Do NOT use just the emergency jack! If you have access to a vehicle lift, that's the best tool to use.
yariseggvvtiThread starterCali · Jan 5, 2013#5
Thanks all for the advice! I am plan buy all the hardware and not bother to take any parts from the stock suspension. I believe this way will make my life easier. I notice it will be cost a bit but I am going to do it myself. Looking forward pushing hard in the corner.
CrankyOldManWest Michigan · Jan 5, 2013#6
Originally Posted by yariseggvvti ↑
I am plan buy all the hardware and not bother to take any parts from the stock suspension. I believe this way will make my life easier. I notice it will be cost a bit but I am going to do it myself.
This is what I did with my front springs/shocks when I put on Tokico blues and Tien S-techs, so now it's just a modular swap. You will need to use a press to install the bearings on the retainer plate, but everything else is just hand tools.
yariseggvvtiThread starterCali · Jan 5, 2013#7
Crankyoldman, in order to press the bearing on the retainer plate. What kind the tool I have to prepare. Its okay rent it from AutoZone.

I am try to get all the information and get it done in the weekend. Yaris is my daily driven vehicle.
CrankyOldManWest Michigan · Jan 5, 2013#8
To press the bearing correctly, you need an arbor or hydraulic press. I have access to a few different sizes at work and at school, so I didn't need to buy one. I don't see them available from AutoZone for rental, but you can probably go to a mechanic and ask them to do it for you. It only takes a few seconds, so they may even do it for free.
yariseggvvtiThread starterCali · Jan 7, 2013#9
I am going to get everything done first before making a move. I dont wanna end up missing of hold up something. Thanks for the advice!