Thanks,ya its tight,but youll have no problem,because neither one will move.
DIY: Groundwire Kit
134 posts · 98,282 views · page 3 of 3
Replies continued
Τell us any comments after installing it!
These kits look like they are for a car show, and not so much for performance. No offense to those who like them, just my opinion.
Is there a kit that sells the wires without the clear plastic covering? Something more opaque like spark plug wires. Maybe I could buy the wires like this somewhere?
Is there a kit that sells the wires without the clear plastic covering? Something more opaque like spark plug wires. Maybe I could buy the wires like this somewhere?
What does it matter if they do the same thing. Why not have a kit that does the same any other kit(one's that look like spark plug wires as you put it) would do, but have it look good at the same time?Originally Posted by SDsurfriderThese kits look like they are for a car show, and not so much for performance. No offense to those who like them, just my opinion.
Is there a kit that sells the wires without the clear plastic covering? Something more opaque like spark plug wires. Maybe I could buy the wires like this somewhere?
Oh and yes there are kits like the way you mentioned.
^ good to hear. Wish i was snowing here in LA, man I miss the snow. Like you said if nothing more is gained from this mod atleast you know your engine/tranny are nicely grounded.
Originally Posted by ItsMyDaily^ good to hear. Wish i was snowing here in LA, man I miss the snow. Like you said if nothing more is gained from this mod atleast you know your engine/tranny are nicely grounded.
Correct🎉
On the pictures I noticed nobody put back the stock grounding point?
Or am I just overlooking it?
It seems hard to fit on the brass thing since it's grooved specifically for the stock version.
Or am I just overlooking it?
It seems hard to fit on the brass thing since it's grooved specifically for the stock version.
I just bought the red ones on ebay:
http://cgi.ebay.com/ebaymotors/ws/eB...3816&rd=1&rd=1
Will post pic when I install them..
-- Blen
http://cgi.ebay.com/ebaymotors/ws/eB...3816&rd=1&rd=1
Will post pic when I install them..
-- Blen
Aw hell...I'm on board too.
This looks simple enough to do. Remebering my last vehicle, I would have paid someone to do this on that vehicle! The nice thing is our alternator and battery is right there and VERY easy to get to.
I'm still considering buying a stock alternator and sending it into Ohio Generators or to Dominick Iraggi to have them do a custom higher Ampere alternator.
Does anyone know the part # for our alternators and the stock output of these things?
This looks simple enough to do. Remebering my last vehicle, I would have paid someone to do this on that vehicle! The nice thing is our alternator and battery is right there and VERY easy to get to.
I'm still considering buying a stock alternator and sending it into Ohio Generators or to Dominick Iraggi to have them do a custom higher Ampere alternator.
Does anyone know the part # for our alternators and the stock output of these things?
Originally Posted by bigsky2 ↑Stock output of the alternator is 90A from what I can remember.
It will support a basic "non-threatening" sound system, but I think it cannot hold its own for more ambitious projects.
Do you think that this would be why my amp will shut off when it gets to loud, and my lights dimming with every hit?
Been there, done that: Add a capacitor and or replace the battery, get a bigger cable for the battery positive and problem solved, don't forget a good fuse...
Picture lost · www.yarisworld.com
Picture lost · www.yarisworld.com
What is the point of running so many ground wires?
I bought a red kit cuz it matches my other upgrades. :) I'll be interested to see if it provides any noticeable difference in the car's performance.
OgDogg,
You may not notice improvements at all if you just randomly ground the wires.
IMO it's does wonders when you dyno test the ground wires so you can ground the wires at the best possible points.
Just a heads up because you maybe dissapointed when you don't feel/notice any improvements.
You may not notice improvements at all if you just randomly ground the wires.
IMO it's does wonders when you dyno test the ground wires so you can ground the wires at the best possible points.
Just a heads up because you maybe dissapointed when you don't feel/notice any improvements.
It makes your car go faster! 🙄Originally Posted by naossoan ↑What is the point of running so many ground wires?
EDIT: In all seriousness though, if you draw more current, you will need less resistance in the wiring. Though this is somewhat debatable.
I was just going to follow this DIY to install it. :) I'm more concerned with the looks and the constant shocks passengers get when getting out of my car. I'm hoping this grounding kit helps a little with that. Out here in the desert there is a ridiculous amount of static electricity, so we'll see if this helps at all. It could just be a pipe dream thinking this will have any effect.Originally Posted by eijikikimaru ↑OgDogg,
You may not notice improvements at all if you just randomly ground the wires.
IMO it's does wonders when you dyno test the ground wires so you can ground the wires at the best possible points.
Just a heads up because you maybe dissapointed when you don't feel/notice any improvements.
Well, I got an oil change today and decided to install my grounding kit when I got the car back. After taking my first ride here are my impressions. Might I also say that I was very skeptical that this would do anything for the performance.
It seemed like the rpms were much lower at cruising speeds than before which made it feel less like the car was struggling to maintain speed. It also felt much smoother shifting through the gears. No delay throwing it into the next gear. That was the most noticeable attribute. It could just be the oil change, but I doubt it. I recommend the grounding kit.
It seemed like the rpms were much lower at cruising speeds than before which made it feel less like the car was struggling to maintain speed. It also felt much smoother shifting through the gears. No delay throwing it into the next gear. That was the most noticeable attribute. It could just be the oil change, but I doubt it. I recommend the grounding kit.
Some one told me that modern cars are grounded pretty well because I really want this but i dont want to waste my money
Translation?Originally Posted by KSIbucky ↑i dont want to waste my mom
sorryOriginally Posted by BailOut ↑Translation?
Well, when upgrading a bottom end car such as the Yaris it's always going to be a waste of money. :) But if you want to slightly improve things and you enjoy working on your car, go for it!Originally Posted by KSIbucky ↑Some one told me that modern cars are grounded pretty well because I really want this but i dont want to waste my money
Ok, i've been into cars and electronics for years now, and I must say that after I installed the kit, I did notice a stronger "feel" to the acceleration than before. Also my transmission (manual), seems to again "feel" better, more accurate than before. I also have a radar detector that can measure my voltage, and I now run an average voltage of 14.3 volts, where as before, my car would run 13.9 volts. I believe because the negative electrons run more freely now throughout my vehicle, there is more of a balance between the stronger positive, and normally weaker negative power within the car to make all power using mechanics more efficient.
Moreover, a better electrical balance throughout the car. For $22.00 shipped, even it it's a facade, and my electrical readings incorrect, it just "feels" better.
Summary: GET IT, it's cheap, and I CAN see a difference with my volt meter!👍
Moreover, a better electrical balance throughout the car. For $22.00 shipped, even it it's a facade, and my electrical readings incorrect, it just "feels" better.
Summary: GET IT, it's cheap, and I CAN see a difference with my volt meter!👍
The grounding kit replaces your whole negative right?... So you have to have one of those wires on the starter?
Excellent DIY Thank you. 🤘 👍
diy guide said posted earlier said to keep the stock negative terminal how do you connect do did you connect the cable to the grounding kit?
I have a 2010 3-Door 4-speed auto with less then 500 miles.
I will order a groundwire kit this week.
Should I wait until after 1,000 miles (the break in period) or after the first oil change (5,000 miles) or should I install the ground wire kit as soon as possible?
I have the fuel saver magnet that covers your fuel line near the engine. That really works. I had it working with my late car (2004 Corolla S - 10 to 15 MPG extra city). So far, about the same increase MPG for my Yaris.
I will order a groundwire kit this week.
Should I wait until after 1,000 miles (the break in period) or after the first oil change (5,000 miles) or should I install the ground wire kit as soon as possible?
I have the fuel saver magnet that covers your fuel line near the engine. That really works. I had it working with my late car (2004 Corolla S - 10 to 15 MPG extra city). So far, about the same increase MPG for my Yaris.
Another troll? 🙄
This DIY helped a lot. Thanks!


I did this earlier this week as well and it turned out better than I'd imagined. The DIY guide helped A LOT. One definite issue I had was getting the adapter off of the negative battery cable. I ended up sawing it off, but not before slicing my knuckles a few times trying to get it off with a wrench. This install was very easy and would've only taken about 45 minutes if it weren't for that pesky adapter on the battery cable.
Anyway, as far as results go, I can't say for sure that it's all based on the new groundwire kit, but my car definitely rides smoother and accelerates better, particularly in the mid-range RPMs. I also feel smoother shifts from my automatic transmission.
However, I absolutely have to note that part of this may be due to the fact that I had the battery disconnected for about an hour, which reset every electrical component in the vehicle (including the engine control unit). So, I would've experienced a smoother ride either way from simply resetting the ECU, but I've reset it before and don't believe the results were this drastic in the past. I haven't had a chance to see any difference in fuel efficiency yet, but it certainly wouldn't surprise me to see an extra 1 or 2 mpg.
-Brian
P.S. Kac, is your air filter just laying out or do you have some strange new intake I've never seen before? I see your sig says you have a modified air intake box. Is there a DIY guide or any more info about it?
Anyway, as far as results go, I can't say for sure that it's all based on the new groundwire kit, but my car definitely rides smoother and accelerates better, particularly in the mid-range RPMs. I also feel smoother shifts from my automatic transmission.
However, I absolutely have to note that part of this may be due to the fact that I had the battery disconnected for about an hour, which reset every electrical component in the vehicle (including the engine control unit). So, I would've experienced a smoother ride either way from simply resetting the ECU, but I've reset it before and don't believe the results were this drastic in the past. I haven't had a chance to see any difference in fuel efficiency yet, but it certainly wouldn't surprise me to see an extra 1 or 2 mpg.
-Brian
P.S. Kac, is your air filter just laying out or do you have some strange new intake I've never seen before? I see your sig says you have a modified air intake box. Is there a DIY guide or any more info about it?
Blacksandiegovits did it first. i just modified the stock air box.
I got the info on how to do it from another thread... don't have a link for ya sorry. search around.
I got the info on how to do it from another thread... don't have a link for ya sorry. search around.
Hey kac!Originally Posted by kac ↑This DIY helped a lot. Thanks!
Was this an ebay item or did you make it yourself? 🤷
Looks nice. 👍
Will the grounding kit be the solution for those nasty static shocks I keep getting every time I close my door?
No birdman, it will not solve that problem :( I've had a grounding kit on for 2 years or so now I think and I still get those nasty static shocks occasionally. Not always, but when it happens IT HAPPENS. I have no idea what causes it though...
Thanks!