Yarisworld Archive

Intake for the 1ZZ throttle body?

10 posts · 12,674 views

fujiOriginal postHonolulu · Jun 11, 2009#1
I am very pleased with the butt dyno performance of the 1zz throttle body. When I put on the Bomz intake, I noticed the tubing is slightly smaller than the diameter of the throttle body itself.

Would there be a benefit to have a custom diameter intake? It would probably be easy to make. The other option is to find another vehicle such as the TS or a Matrix/Corolla pick up a short ram intake an use it instead.

Do you think doing this would make anymore power? It could possibly really make a difference with a different intake manifold.

Replies 9

yaris-meAnaheim, CA · Jun 11, 2009#2
You need to look at the inside diameter. I don't think a slight difference would affect performance. If anything the MAF sticking out in the middle of airflow creates more restriction.😁
TamagoOff Grid · Jun 11, 2009#3
i wouldn't recommend a larger diameter intake tube either. wreaks havoc on the ECU if you don't compensate for it.
thebarberGrand Rapids, MI · Jun 12, 2009#4
Originally Posted by Tamago ↑
i wouldn't recommend a larger diameter intake tube either. wreaks havoc on the ECU if you don't compensate for it.
agreed....i tried my intake from my matrix, which was 2.5", and it was incompatible w/ my yaris
fujiThread starterHonolulu · Jun 12, 2009#5
Wow, so the consensus is there would be no benefit in increaseing the diameter of an intake piping to match the throttle body?
tk-421Dagobah · Jun 12, 2009#6
I think there would be a much higher improvement by port matching the intake mani to the new TB diameter. Even then the change wouldn't be drastic.
thebarberGrand Rapids, MI · Jun 13, 2009#7
Originally Posted by fuji ↑
Wow, so the consensus is there would be no benefit in increaseing the diameter of an intake piping to match the throttle body?
i got a CEL for running lean....
EdgarTRD1.8Hormigueros, Puerto Rico · Jun 13, 2009#8
I'm building a 1nz-fe Aluminum Intake Manifold with 1zz-fe Throttle Body. The Intake is like this on the 3TC but is littler than this one and has an inclination. I'll take some pics to post step by step the process. Only I need is the 1zz TB to drill the spacer to bolt it and weld, a friend has one but he doesn't bring it to me yet.
Picture not included in this copy
bladesmith6PA · Jun 13, 2009#9
Tried a larger diameter tube threw a code right away, the sensor is very touchy.
yaris-meAnaheim, CA · Jun 14, 2009#10
Originally Posted by fuji ↑
Wow, so the consensus is there would be no benefit in increaseing the diameter of an intake piping to match the throttle body?
Yes. Unless you have this:
intake manifold photo

Then you need to port and polish, and match intake openings.🎉