How do you guy remove the foggy covers ? Wanna open them up to let more air in.
How to remove fog lamp covers ?
9 posts · 9,010 views
Replies 8
Water may get into them and cause the bulbs to blow premature due to condensation.
Mine are just covers, I dont have fogs.
AFAIK they clip from the back, it'd be easier to remove the bumper to reach the clips...
alternatively, on each side you can remove three screws and a plastic plug (where the centre screw goes in) underneath the bumper - check out the service manual fog lamps under "lighting".
Pull out and flex the plastic shielding out to one side and stick your hand in - push the clips on the fog cover outwards and push forward - it may be easier if you have a buddy to assist and jacking up the car/or put on ramps depending how fat you are....
Pull out and flex the plastic shielding out to one side and stick your hand in - push the clips on the fog cover outwards and push forward - it may be easier if you have a buddy to assist and jacking up the car/or put on ramps depending how fat you are....
instead of taking them out completely i thought about using the dremel to cut some slits to give it some air.....
why don't u install billion air funnel and air duct instead. it's looks better.Originally Posted by nurburgring ↑How do you guy remove the foggy covers ? Wanna open them up to let more air in.
That is what I'm going to do, just can't find the dremel right now..🤷Originally Posted by ROCKLAND TOYOTA ↑instead of taking them out completely i thought about using the dremel to cut some slits to give it some air.....
iif u have the CAI it probably help to open it.. its right under where the filter goes .. was thinking about doing it too.. when its not raining..