Replies continued
Black YarisToledo, OH · Jul 22, 2007#51so you got about 40whp from?
Engine Port and Polish
Engine Compression increased 0.6mm
Engine Balance
DASTEC Unichip Type Q Fuel Management System
brickhardmeatInner City, Dallas · Jul 22, 2007#52[QUOTE=red-jdm;113990]
Originally Posted by
brickhardmeat ↑ This guy must be an Indonesian prince or somethin'...
😆 hahahaa great comment...
I'm not a prince for one, as I'm not a guy!!!
but I own a modification shop in jakarta though, modification is my hobby
sorry princess
red-jdmJakarta (indonesia) · Jul 22, 2007#53[QUOTE=brickhardmeat;113993]
Originally Posted by
red-jdm ↑
sorry princess
😉 no prob mate
red-jdmJakarta (indonesia) · Jul 22, 2007#54 Originally Posted by
Black Yaris ↑ so you got about 40whp from?
Engine Port and Polish
Engine Compression increased 0.6mm
Engine Balance
DASTEC Unichip Type Q Fuel Management System
not just that, all others counts too, ie. exhaust manifold and center pipe
Black YarisToledo, OH · Jul 22, 2007#55 Originally Posted by
red-jdm ↑ Are you asking if I had my car dyno tested on wheels or engine? On engine of course, not on wheels. The standard car (thai/indonesia's yaris) comes with 109 hp on engine, listed on its specification.
You can look at my mods in my profile
I understand the probibly dynoed it at the crank when they did the port and polish/balance but WHP is what matters.... Yes the Yaris make 109HP at the crank from the factory, but it only puts about 87-90 to the ground..... so you may want to get your car dynoed for some more accurate # at the wheels
Black YarisToledo, OH · Jul 22, 2007#56 Originally Posted by
red-jdm ↑ not just that, all others counts too, ie. exhaust manifold and center pipe
I did not take those into account because 90% of Yaris tuners have those done already... that is why I only said 40HP.... Exhaust+intake maybe 10HP in cunjuction with everything else
red-jdmJakarta (indonesia) · Jul 22, 2007#57yes, agree, dyno on wheel will be great. A bit curious with that too. .
however, mind you that this sort of car is also sensitive with its actual weight..the lighter it is, the faster it can go..."power to weight ratio"
cali yarisCanoga Park, CA · Jul 22, 2007#58lightweight flywheel isn't hurting it either 😉
cali yarisCanoga Park, CA · Jul 22, 2007#59 Originally Posted by cali yaris
I know, sometimes we can't help jumping all over someone, but...
this thread could have been copied right off of ScionLife....
I thought YarisWorld was a cut above all that?
Comon It wasn't that bad...!
Turns out... it was. Ah, kids these days... no self control.. lol
tca4Delta,BC · Jul 22, 2007#60Tanabe NF Coilover Kit Suspension??
kurokoma-kunmy own little world · Jul 22, 2007#61 Originally Posted by
tca4 ↑ Tanabe NF Coilover Kit Suspension??
just wondering same thing...
brickhardmeatInner City, Dallas · Jul 22, 2007#62 Originally Posted by
kurokoma-kun ↑ just wondering same thing...
I think this person is referring to coil springs as coilovers.
Looking at the photos though there is no way that is nf springs unless they're hacked. That car is tucked and you don't get any tuck with NF's.
The spring rates are way high. I can't find anything with those spring rates. Must be a custom job.
red-jdmJakarta (indonesia) · Jul 23, 2007#63yes you guys are correct. The actual rate of tanabe springs for the nf kit coil over is 3K front and rear. I bought another springs which have harder spring rate but similar diameter for me to use in the circuit only, as the original is not hard enough. I use the original springs only for street use.
tndIndonesia · Jul 23, 2007#64Anything is possible of course..
FYI she is the sole distributor for Tanabe products in Indonesia...👍
red-jdmJakarta (indonesia) · Jul 23, 2007#65hi tnd great to find you here
AlphaFoxSpringfield, Mass · Jul 23, 2007#66so, should we refer to you as a modess', derived from modder? hehe
brickhardmeatInner City, Dallas · Jul 23, 2007#67 Originally Posted by
red-jdm ↑ yes you guys are correct. The actual rate of tanabe springs for the nf kit coil over is 3K front and rear. I bought another springs which have harder spring rate but similar diameter for me to use in the circuit only, as the original is not hard enough. I use the original springs only for street use.
so what tanabe coilover kit is this? sustec?
tndIndonesia · Jul 23, 2007#68 Originally Posted by
brickhardmeat ↑ so what tanabe coilover kit is this? sustec?
Yep, sustec Pro NF coilover kit.. and she ordered another set of 'harder'
spring from tanabe.. coz the stock NF springs are tooooo soft for circuit usage .. 😛
sdmfchicago · Jul 23, 2007#69 Originally Posted by
bearda ↑ Mazdaspeed and Nismo stickers look hot on the Yaris. Trust me.
no way its ralliart and mugen with the classic vtech inside sticker
seaneleSoCal · Jul 29, 2007#70 Originally Posted by
tk-421 ↑ Hey... a guy can dream, right? 🙄🙌
dang..., so it's all just a dream??....😢