Yarisworld Archive

Speed Accuracy...

11 posts · 17,317 views

NeinrisOriginal post‘Murica! · Feb 1, 2021#1
The Yaris is said to have two different stock wheel/tire combo, the 175/65/R14s and 185/60/R15s. Currently I have 185/60/R15s, and my speedometer reading is off by 2MPH, where it reads 60MPH, when I'm actually going 62MPH. So I believe my car is dialed for the 175/65/R14 combo. It's kind of bothering me and want it fixed. Am I the only one having this issue? I don't want to go with smaller tires because currently the tire size I have fill my wheel well nicely. Is there a part number difference for the speed sensor that goes in the transmission? 😕

Replies 10

kevinj93Sydney, Australia · Feb 2, 2021#3
Hmm, my speedometer reads faster that the actual speed.

Interestingly, If I take the output from the OBD port, it agrees with GPS speed. I wonder if anyone knows if it is possible to physically open the speedometer and adjust it?
NeinrisThread starter‘Murica! · Feb 3, 2021#4
Originally Posted by Mister ↑
https://yellr.com/

Yootoobers use this?
Interesting... Thank you! I might get this.
RedRideMiddletown, NY · Apr 30, 2022#5
With my '09 HB The speedometer is dead on

This is according to all those solar powered speed read outs that a lot of towns use.
When a readout says 30 MPH (in a 30 MPH zone) that is exactly what my speedometer says also.

This is with 185/60/R15s tires as this is the size that came with it 🙂
NeinrisThread starter‘Murica! · Oct 13, 2022#6
I discovered that there ARE two different part numbers for the speedometer driven gear sun-assembly!!!

One specifically states 185/60R15, I’m going to order it and install and see if that fixes my speed difference issue that’s bee driving me nuts for years!!! 🤣

1 attachment not included in this copy

NeinrisThread starter‘Murica! · Nov 2, 2022#7
Is there a special tool to remove the speed sensor that's in the manual transmission? I couldn't get mine off to try and replace the gear sub-assembly. And yes, I removed the bolt that was holding it. 🙄
sh0rtlifepacific north WET · Nov 2, 2022#8
assuming its like all the rest ..its a very..VERY tight fit and just needs more effort..alot of them are a neer press on fit, you could always try tossing it in the freeze for a couple hours to shrink the metal its on
remcafeeArizona · Nov 2, 2022#9
it should be sealed by an o ring, sometimes they fuse themselves to the case, just keep struggling, swearing, and fucking up your hands until its out lol
NeinrisThread starter‘Murica! · Nov 2, 2022#10
Originally Posted by remcafee ↑
it should be sealed by an o ring, sometimes they fuse themselves to the case, just keep struggling, swearing, and fucking up your hands until its out lol
LOL!!! 😆
sh0rtlifepacific north WET · Nov 2, 2022#11
ah the actual sensor..is there room to get a carpenters blade under it?..ive used them as a puttyknife on things like that in the past to work them up just enought o actuly get a puttknife in there to work them more