Originally Posted by
Brettguy ↑ Thinking about buying something to show my oil pressure and temp since I currently have none. Anyone with gauges ever see oil temps higher than 230 or so? I just did another high-speed road trip and started thinking about this. Most experimental thing I would do is run a 0w or 5w40. just wondering if it would be justified for towing or 100mph driving
Sent from my SM-N910T using Tapatalk
100mph although faster than a typical commute, is not necessarily much harder on an engine. Sure, the engine is working harder but no where near WOT with a full load on the engine. RPM's are elevated but that alone is not an indicator of engine or oil stress.
If you were going to get an oil gauge for curiosity's sake then get an oil pressure gauge. Temp is pretty much irrelevant as you will never get above or even close to 300F and a solid synthetic oil and even convention with proper oil change intervals can handle that for relatively brief windows of time.
Oil pressure is more important because it shows you if your engine oil is within factory spec for which the engineers designed the engine for. Temps can fluctuate but pressures may still be within spec and Toyota has very wide specs for oil pressures (at least for the 2zr engine). A manufacturer specifies an oil viscosity that keeps the pressure within the specs that they built the engine for. I almost made a wrong assumption and went with a 5w40 oil for this upcoming track season. I wrongfully assumed I was out of oil pressure spec as my idle pressure after a track session was 5-6psi with a 5w30 oil. I assumed because my on track oil temps (280-290*) were well above the standard operating temp of 212* that I needed to switch to a viscosity that would operate at the same viscosity at track temps as the factory weight does at 212*.
Based on a few factors and hours of hours of reading I will be going to a 0w20 for this upcoming season, even with my oil temps hitting 280-290*. The only way I will go back up to a 30w oil is if my oil pressure falls below toyota's spec.
Your driving habits definitely don't warrant a gauge, but if your curiosity does then grab an oil pressure gauge. You can T it off of the factory sensor location. Viscocity is not the important factor when it comes to wear and believe it or not neither is temp. 275*-315* has almost identical wear protection across all oils relative to themselves.
Read this extremely useful website
https://540ratblog.wordpress.com/201...-test-ranking/ if you want the short answer of what easy to find off the shelf cheap oil to run that will offer the most protection: go with Quaker State Ultimate Durability full synthetic 0w20 (5w30 i suppose since you have the 1nz). The 0w20 has better wear protection but the 5w30 is still very high on the list.
Second best off the shelf oil would be Pennzoil Ultra Platinum 5w30. This is the oil I ran for 13k km straight last year, 800-900 of those km's were on the track and each time I hit 280* at least for around 10-30 mins. I posted my used oil analysis on this forum and it came back excellent
Your oil temps will not be hitting what I saw on the track since your engine is not nearly as stressed on the highway. I only started noticing the oil temps climb once my coolant got to 230* and that was about 10 minutes into a session of constant WOT and driving close to redline. To put it in perspective I would go through over 3/4 of a tank of gas in about 120km on the track. keep doing what you're doing just do your engine a favor and run one of the oils high on the list posted on 540ratblog