Yarisworld Archive

Penguin garage axle spacer

16 posts · 6,744 views

Tskm2Original postMontreal · Dec 30, 2018#1
Search for a set or someone with draw of all measure to made one. Fors 06-07yaris

Replies 15

tmontagueCaledonia Ont. · Dec 30, 2018#2
If you can wait until the spring I will he selling my 10mm penguin spacers with camber washers.

I'm going to a wider 225 track tire and that wont fit with the 10mm spacers
LeegamerAshland, VA · Dec 31, 2018#3
Are you just looking for slip-on spacers? If so there are a billion companies that sell them.
Tskm2Thread starterMontreal · Dec 31, 2018#4
Pm's tmontague

I run wheel spacer on all my car/truck. But couple years ago a made a set of axle spacer for my jetta mk2 and it so much better and on wheel bearing too
enviriCT · Jan 3, 2019#5
found mine :P these are way too tight to fit hubs with abs. it really sucked removing these from my hub.

Picture not included in this copy
myfirstyotaToronto Canada · Jan 17, 2019#6
If any Canadians are looking for a more local sale of their spacers, I'd be interested
06YarisRSFredericton, New Brunswick, Canada · Jan 17, 2019#7
Originally Posted by enviri ↑
found mine :P these are way too tight to fit hubs with abs. it really sucked removing these from my hub.

Picture not included in this copy
Interesting. Mine weren't a bad install at all. Getting the hub off before the spacer install was tough, but putting it all back together was a breeze, but I did have the mechanical advantage of the bolts. However, removal, that may be a different story.

Now you've got me wondering...does my '06 have ABS? Haha. The install was a while ago.
enviriCT · Jan 17, 2019#8
go slam your brakes and report back lol
06YarisRSFredericton, New Brunswick, Canada · Jan 18, 2019#9
Originally Posted by enviri ↑
go slam your brakes and report back lol
😆 - a valid test for sure. However, since it's still up on stands with the front torn off, I'll look for the sensors. LOL.
myfirstyotaToronto Canada · Jan 18, 2019#10
Originally Posted by enviri ↑
found mine :P these are way too tight to fit hubs with abs. it really sucked removing these from my hub.

Picture not included in this copy
I've had to use a slide hammer every time to get the rear hubs out.
tmontagueCaledonia Ont. · Jan 18, 2019#11
I opted for the air chisel when I had to remove them to install the spacers. Now I never have any issues since everything is covered in anti seize. If only the factory would do the same...
Tskm2Thread starterMontreal · Mar 20, 2019#12
In search again!
Tskm2Thread starterMontreal · Mar 20, 2019#13
Or someone he's able tho draw/template exactly on sheet and mail for a made custom one. I dont have old/scrap bearing to take measure
Tskm2Thread starterMontreal · Mar 28, 2019#15
Alrigth thank! I print it and try the template!
06YarisRSFredericton, New Brunswick, Canada · Mar 28, 2019#16
I think this will make many people happy!