rabbitoOriginal postThailand · Feb 11, 2017#1i failed to install the 1zz throttle body due to...
1. fu*ken coolant hose being too short and couldnt reach the throttle body..😣
2. i wanted to use stock intake box with plastic hose but couldnt fit over 60mm..lol.. 😥
is anybody using stock airbox for 1zz 60mm tb? i custom ordered stainless steel intake 2.5" from a shop to try to make it possible...(picture below..sorry for sucky drawing..) 😆
if not..how is your car running on normal intake + 1zz throttle body??
im trying to use stock box because i hate losing low end torque..i had hks intake which lost low end and gained hi end
Picture not included in this copyPicture not included in this copy Sent from my SM-N920C using Tapatalk
2 attachments not included in this copy
Replies 5
SirDigbyDenver, Colorado · Feb 11, 2017#2I took a piece of 90 degree copper tubing and plugged the coolant lines together around the corner of the head by-passing the throttle body. you would need to replace the hoses, at least 1, with aftermarket tubing. if you want to use stock air box /w accordion rubber duct, I've read that you can turn the tube around 180 degrees and it fits on 1zz. I have not tested. I have a injen CAI.
rabbitoThread starterThailand · Feb 11, 2017#3 Originally Posted by
SirDigby ↑ I took a piece of 90 degree copper tubing and plugged the coolant lines together around the corner of the head by-passing the throttle body. you would need to replace the hoses, at least 1, with aftermarket tubing. if you want to use stock air box /w accordion rubber duct, I've read that you can turn the tube around 180 degrees and it fits on 1zz. I have not tested. I have a injen CAI.
dude...that was so helpful..thank you ✊✊✊✊
Sent from my SM-N920C using Tapatalk
ncp13Athens Greece · Feb 12, 2017#4I think you can do without the coolant lines on the TB in Thailand. :wink
You can probably leave them in loop.
Cooland flows there to prevent icing and sticking of the throtle plate with frozen condensation vapors.. not a case in your part of the world I think :)
tmontagueCaledonia Ont. · Feb 12, 2017#5Yes, you can definitely by pass the coolant. I just bought generic coolant hose and cut it to fit for the 1zz TB. I didn't want to bypass the coolant as I live in a cold climate.
I had a TRD intake that came with a silicone coupling. It was too small to fit over the 1zz but i was able to stretch it to fit and clamp it downs with a zip tie. The stock hose is stiffer and not as easily stretched.
FluxtasyMalaysia · Feb 15, 2017#6Hi rabbito, I think 1ZZ TB is 55mm unless your using Thai TB which I saw is 60mm. You could just purchase a longer coolant hose with custom length.
I'm using 1ZZ TB with stock air intake. Tooter mentioned that I could use the stock hose by just switching the ends but it is a very tight fit for 55mm. Might need to stretch/force it a little for TB side.