jackmilasOriginal postPoland · Oct 18, 2016#1Hi,
Here are the symptoms:
- red temperature warning light starts flashing after some time, usually in city traffic
- when the above occurs the radiator fan does not spin
- the fan spins when I engage AC (even when the engine is cold)
I exchanged FAN N.01 relay switch with HORN relay switch to see if the horn works and it does. When I remove the FAN N.01 relay and connect two pins with a wire as marked in the picture below, the fan starts spinning.

Replies 6
jcboyAsia · Oct 18, 2016#2Based on your observations the trigger of the relay (in the wiring) is faulty, but assuming the AC uses the same relay, then more likely the culprit is the thermoswitch than the thermostat.
Sent from my G9208SS using Tapatalk
jackmilasThread starterPoland · Oct 18, 2016#3Thermoswitch is normally open?
Is it connected directly to FAN N.01 or FAN N.02 relay?
CTScottUSA, CT · Oct 18, 2016#4The fan No 1 relay coil is controlled by the AC ECU.
It in turn feeds as one of the triggers for the Fan No 2 relay (and gives the AC ECU the ability to turn the fan on when the engine is not hot).
The Fan No 2 relay also has two other triggers in parallel with the AC ECU (so any of the three can turn it on): ECM output CF (cooling fan) and Water temp switch.
The fact that bypassing No 1 makes it turn on just tells you that either the ECM output or the water temp switch is the issue.
jackmilasThread starterPoland · Oct 19, 2016#5 Originally Posted by
CTScott ↑ The fan No 1 relay coil is controlled by the AC ECU.
It in turn feeds as one of the triggers for the Fan No 2 relay (and gives the AC ECU the ability to turn the fan on when the engine is not hot).
The Fan No 2 relay also has two other triggers in parallel with the AC ECU (so any of the three can turn it on): ECM output CF (cooling fan) and Water temp switch.
The fact that bypassing No 1 makes it turn on just tells you that either the ECM output or the water temp switch is the issue.
Where is the ECM output located?
jackmilasThread starterPoland · Oct 19, 2016#6Today I managed to get the fan running when I shorted the wires from Water Temp Switch plug. So it seems the switch is not working. I'm replacing it tomorrow.
CoryMWhite Rock BC · Oct 20, 2016#7If you haven't done so, you may want to check your coolant level. Those switches only work when submerged.