Yarisworld Archive

Removing lower rear spring perches?

4 posts · 3,866 views

lormagniOriginal postItaly · Oct 24, 2015#1
Hi guys, just had my Vogtland lowering springs installed two weeks ago after removing the Eibach ones that were too harsh to ride on. I noticed that both springs sets tend to leave the car higher in the rear (my wheelgap is two fingers in the front and two and half/three in the rear). I was thinking about removing the lower rubber perch in the picture below to make the car sit lower in the back. Is it possible or this will cause too much rattling/noise/damage?

1 attachment not included in this copy

Replies 3

MUSKOKA800Chatham, Ontario, Canada · Oct 24, 2015#2
As the rubber appears to centre the spring I would imagine much rattling, squeaking and spring misalignment if removed.
24boostedSC · Oct 24, 2015#3
You can run Energy Suspension custom spring isolators. Just measure the donut size needed. There are various diameter and thicknesses.
MUSKOKA800Chatham, Ontario, Canada · Oct 26, 2015#4
Originally Posted by 24boosted ↑
You can run Energy Suspension custom spring isolators. Just measure the donut size needed. There are various diameter and thicknesses.
The OEM item is quite thin. It might be tough to find an aftermarket item any thinner.