ab15Original postuk · Jul 12, 2015#1Hi, yes I have read the other treads.
2005 Toyota Yaris Verso 1.4 diesel.
Stuck on 2 bars on the gauge.
I have replaced the fuel gauge sender and pump, replace the lcd display and still it is stuck on 2 bars.
Any help - Thanks
Replies 8
CTScottUSA, CT · Jul 12, 2015#2Sounds like the wire between the sender and instrument cluster might be pinched. Do you have access to a multimeter to take some resistance measurements?
valchrist90731Los Angeles County · Jul 12, 2015#3Try to run it down to one bar.
Can it do this?
ab15Thread starteruk · Jul 13, 2015#4When run empty it just goes from the stuck 2 bars to flashing.
I have checked the violet wire and it doesn't read anything.
valchrist90731Los Angeles County · Jul 13, 2015#5Follow the wires from display unit and check the rear connector from gas tank. What corresponds with the rear wiring to the front gas guage display focus on those.
Just tell me all the colors coming from the gas tank basically.
Then we go from there.
.
CTScottUSA, CT · Jul 13, 2015#6The fuel sender should read from 4 ohms with the tank full to 107 ohms with the tank empty.
With the ignition off and the connector pulled from the back of the instrument cluster, measure the resistance between the violet wire in pin 12 and the brown wire in pin 9.
There are two junction connectors between the fuel sender and the cluster. One is on the brown wire and is IB1 (a grey 13 pin connector under the dash). The other is on the violet wire and goes into the back of the under dash fuse panel on connector 1F and exits it to head back to the sender at 1T on the front of the under dash fuse panel.
ab15Thread starteruk · Jul 14, 2015#7I have used a meter on any violet wire I could find, was 2 off them that go into the lcd display, no readings at all.
Have tried to check for connecters under the dash, but there seems to be a big plastic plate at the back of the fuse box, so cant see.
The violet wires coming out of the front top of the fuse box connecter also give no reading.
When the new fuel sender/ pump was fitted, I disconnected the wires and the fuel gauge flashed, then back onto 2 bars when fitted.
I will check the colour of these fuel sender wires by the tank tomorrow and try and trace them under the carpet. cheers
CTScottUSA, CT · Jul 14, 2015#8 Originally Posted by
ab15 ↑ I have used a meter on any violet wire I could find, was 2 off them that go into the lcd display, no readings at all.
Have tried to check for connecters under the dash, but there seems to be a big plastic plate at the back of the fuse box, so cant see.
The violet wires coming out of the front top of the fuse box connecter also give no reading.
When the new fuel sender/ pump was fitted, I disconnected the wires and the fuel gauge flashed, then back onto 2 bars when fitted.
I will check the colour of these fuel sender wires by the tank tomorrow and try and trace them under the carpet. cheers
You mentioned also changing the LCD. Did you change the entire instrument cluster?
Also, if you can snap pictures of the instrument cluster connectors, I can tell you exactly which wires to test.
akis28greece · Jul 22, 2015#9i have the same problem it says 4 bars and 80 km until its empti.but it let my at 78km ant 4 bars whit empty full.