Yarisworld Archive

1NZ-FXE forged rods??

10 posts · 11,052 views

crazylegsOriginal postWinnipeg, canada · Jul 11, 2015#1
Was just looking at wikipedia at different Toyota engines and noticed that the 1NZ-FXE has forged steel rods and also noticed it also runs a high compression ratio. Like the Prius. I know this engines output is much lower then our stock set-up but it got me wondering if anyone looked into mating the rods with our stock engines. Can it even be done as a straight swap, and how much more power could this allow you to push theoretically. I'm sure the stock rods are only reliable to 200whp.

Like I said just stumbled on the info and I though I'd ask.

Replies 9

xnamerxxso cal · Jul 11, 2015#2
Rods are the same between the fe and fxe.
crazylegsThread starterWinnipeg, canada · Jul 11, 2015#3
Originally Posted by xnamerxx ↑
Rods are the same between the fe and fxe.
I was just reading this which made me assume the fxe had something special in forged rods while the fe did not.

https://en.m.wikipedia.org/wiki/Toyota_NZ_engine
crazylegsThread starterWinnipeg, canada · Jul 11, 2015#4
It also states that the fxe has an aluminum intake manifold which makes me wonder could we use the mate the intake flange from the fxe with the intake manifold from the 1zz engine. That's assuming the intake manifold on the fxe and the fe are the same. And the 1zz intake manifold is aluminum.

Just thinking out loud here
Flipper_1938Kentucky · Jul 29, 2015#5
Fxe has a funky intake manifold tuned for a narrow rpm band.

Picture not included in this copy
crazylegsThread starterWinnipeg, canada · Jul 30, 2015#6
Good to know thank you
thebarberGrand Rapids, MI · Apr 14, 2020#7
Is anyone aware as to whether you can just pop a Prius 1.5 in the car while running your stock engine peripherals so that you have a high compression engine?
Neinris‘Murica! · Apr 15, 2020#8
Originally Posted by thebarber ↑
Is anyone aware as to whether you can just pop a Prius 1.5 in the car while running your stock engine peripherals so that you have a high compression engine?
😳 😳 😳

Start looking for a wrecked Prius and test this out!!!
thebarberGrand Rapids, MI · Apr 17, 2020#9
Originally Posted by Neinris ↑
😳 😳 😳

Start looking for a wrecked Prius and test this out!!!
I’ve found a Prius 1nzfxe engine for $100 but it has about 200,000 miles on it. Not sure I want to take the time. The #QCYaris will almost certainly be getting the extra 1nzfe engine I have from TMontague.
ZedicusSW KS · Apr 22, 2020#10
the prius C engine is the one to use to make any substantial 'gains'. the original prius 1.5l engine is basically identical internal except for pistons. you can swap pistons to the yaris 1.5l, or swap yaris cams to the original prius engine.

the prius c engine has newer designs on some of the problematic 1nz issues (valve stem seals come to mind) but it requires 'some work' to install.

i have a write up on an install in a 1st gen scion XB, i will post some.