I believe I've tracked down some 60/40 seats for my Yaris. How hard is it to swap out the seats?
60/40 for bench seat Swap
7 posts · 4,003 views
Replies 6
Depending on the age of your car, the bolts can be almost impossible to remove. They're reverse Torx head bolts (E-type?) and can strip fairly easily. I don't know about a DIY, but there should be some info in these forums.
The 60/40, as you'll see in the links above, requires more bolts than the solid bench. The holes in the floor pan for the extra bolts do not exist. For some, there is a receiver nut in place, requiring a hole to be drilled to it. There is another one where no hole or nut exists.
I've put a 60/40 in mine, but have yet to drill out for the additional bolts. As far as welding is concerned, I don't see why it is necessary to weld the extra nut in. I would think a nut and washer drawn tight would suffice.
I've put a 60/40 in mine, but have yet to drill out for the additional bolts. As far as welding is concerned, I don't see why it is necessary to weld the extra nut in. I would think a nut and washer drawn tight would suffice.
I posted a DIY when I did one on my red Yaris. You could use nuts if you have a helper and will have them again if you ever need to remove it. I welded mine.
Do the years of the seats matter much for how much work is involved? Seems like i have the crappy end of the stick for installation lol
No, all Gen2 seats are constructed the same. I have an '06 and put in seats, front and rear, from a '10.Originally Posted by th3fitz ↑Do the years of the seats matter much for how much work is involved?
Elaborate.Originally Posted by th3fitz ↑Seems like i have the crappy end of the stick for installation lol