Yarisworld Archive

Convert electric wing mirrors to heated?

11 posts · 6,809 views

TwoferOriginal postAuckland, NZ · Mar 28, 2015#1
Hi all,

I have a 2015 Yaris SX that I am slowly getting used to. I remember reading somewhere that it is possible to add a heating component to electric wing mirrors (plus instructions), but can't find it now. I did ask my Toyota service agent if it would be possible, but they said it would be horrendously expensive due to all the rewiring required. Any suggestions out there? I am technically challenged so would have to have it done by a pro/Toyota. Thanks.

Replies 10

CTScottUSA, CT · Mar 28, 2015#2
In many markets the Yaris is pre-wired for it, so you just have to add the heating elements to the mirrors. In a worst case you are only running two wires through the door.
TwoferThread starterAuckland, NZ · Mar 29, 2015#3
Thanks for replying. Since I am in New Zealand (Australasia) I wouldn't think it would have been prewired. Any way it can be checked without dismantling the car?
CTScottUSA, CT · Mar 29, 2015#4
If you can track down the wiring diagrams for your area you can be sure before popping panels.
Eduardo_mtyMar 29, 2015#6
CTScott,do you think the 2015 french versión is pre-wired?
CTScottUSA, CT · Mar 29, 2015#7
Originally Posted by Eduardo_mty ↑
CTScott,do you think the 2015 french versión is pre-wired?
I am not sure if all are, but it was available for some areas from 2012 on for French made ones.
TwoferThread starterAuckland, NZ · Mar 30, 2015#8
Thanks Bairjo. No wonder the Toyota tech said it was expensive! I had hoped that since the mirrors already had electrical wiring, the wiring could be piggy-backed. Bummer :-( Thanks anyway. Cheers.
CTScottUSA, CT · Mar 30, 2015#9
Again, it depends on year and area. You may be prewired
bairjoMar 31, 2015#10
Originally Posted by CTScott ↑
Again, it depends on year and area. You may be prewired
Exactly....Don't let my video discourage you on your efforts. My Yaris appeared to be semi pre wired. What I mean is that you may not need to do all the splicing and wire runs that I did. I clipped the wires at the kick plate wire harness since there was no power feeding it there.
Your Yaris may be ready to "plug and play". Just slap a few sticky pads on the back of the glass and run a pair of wires into the door. If I would have had that situation, the job would have been a snap, even though it really wasn't that bad as I did it.
TwoferThread starterAuckland, NZ · Mar 31, 2015#11
Thanks. I will see how the car deals with our winter (just around the corner) before I decide whether it is an essential or just a "want" :-). Cheers