Hi everyone,
So I would have liked to have a bumper protector/scuff pad for may '09 Yaris installed by the dealership, but the price tag was just a bit too high in my opinion. They were asking for about $60+labour.
With that I decided to try and do it myself, so I headed over to the next best place where you can (sometimes) find quality OEM parts...the junkyard.
I picked up this bumper protector/scuff pad from an '05 Echo for about $10.
Picture not included in this copy
Doesn't get more OEM than this:
Picture not included in this copy
I thought it was looking a bit rough, so I hit it with a couple of coats of gloss black. (It's plastic after all.)
Picture not included in this copy
Picture not included in this copy
I also removed the old glue used to attach the protector/pad to the bumper as it didn't look like it would do a good enough job of protecting against water ingress.
Picture not included in this copy
Next step, I cleaned up all the sealing surfaces with some rubbing alcohol. I committed to having the protector/pad on for the rest of the car's life, so I used some left over Permatex I had along the edges, just like putting on a gasket.
Picture not included in this copy
Fitment was easy. I just aligned the 2 markings on both the protector/pad with the centre mark of the bumper.
...and the final product:
Picture not included in this copy
Picture not included in this copy
Total cost:
-Bumper protector/Scuff pad------$10
-Gloss black paint------------------$4
-Black Permatex liquid gasket-----$7
-Rubbing alcohol--------------------$3
-------------------------------------------
--------------------------------------$24
Tools Used:
-Scrapper (to remove old glue)
-Disposable gloves
Now...I wonder if it would have been cheaper/easier to make it out of simple rubber mat that you can pick up at most hardware stores...
So I would have liked to have a bumper protector/scuff pad for may '09 Yaris installed by the dealership, but the price tag was just a bit too high in my opinion. They were asking for about $60+labour.
With that I decided to try and do it myself, so I headed over to the next best place where you can (sometimes) find quality OEM parts...the junkyard.
I picked up this bumper protector/scuff pad from an '05 Echo for about $10.
Picture not included in this copy
Doesn't get more OEM than this:
Picture not included in this copy
I thought it was looking a bit rough, so I hit it with a couple of coats of gloss black. (It's plastic after all.)
Picture not included in this copy
Picture not included in this copy
I also removed the old glue used to attach the protector/pad to the bumper as it didn't look like it would do a good enough job of protecting against water ingress.
Picture not included in this copy
Next step, I cleaned up all the sealing surfaces with some rubbing alcohol. I committed to having the protector/pad on for the rest of the car's life, so I used some left over Permatex I had along the edges, just like putting on a gasket.
Picture not included in this copy
Fitment was easy. I just aligned the 2 markings on both the protector/pad with the centre mark of the bumper.
...and the final product:
Picture not included in this copy
Picture not included in this copy
Total cost:
-Bumper protector/Scuff pad------$10
-Gloss black paint------------------$4
-Black Permatex liquid gasket-----$7
-Rubbing alcohol--------------------$3
-------------------------------------------
--------------------------------------$24
Tools Used:
-Scrapper (to remove old glue)
-Disposable gloves
Now...I wonder if it would have been cheaper/easier to make it out of simple rubber mat that you can pick up at most hardware stores...