GrayYarisOriginal postNY · Apr 25, 2014#1Anyone know where to pick one up? My local Toyota dealer can't seem to get me one. I lost the old one in the dirt but I'm sure I can just put a normal cotter pin in there. It seemed to have a stainless finish because it was not rusted out like my tie rod end cotter pin. It was a breeze to pull out.
I am embedding a diagram off of the manual at micro image to clarify which pin I'm talking about.
The diagram identifies the part as "CLIP"
Replies 5
CTScottUSA, CT · Apr 25, 2014#2The part number of the clip is 90468-16022. It is an $0.88 part from the dealership.
GrayYarisThread starterNY · Apr 25, 2014#3 Originally Posted by
CTScott ↑ The part number of the clip is 90468-16022. It is an $0.88 part from the dealership.
Thanks Scott. My dealer is ordering them at $1.40 a piece. Couldn't seem to figure out the part until I gave them the number.
CTScottUSA, CT · Apr 25, 2014#4 Originally Posted by
GrayYaris ↑ Thanks Scott. My dealer is ordering them at $1.40 a piece. Couldn't seem to figure out the part until I gave them the number.
It's pretty sad that I am more skilled with Toyota part number searching than most dealers are.
GrayYarisThread starterNY · Apr 25, 2014#5 Originally Posted by
CTScott ↑ It's pretty sad that I am more skilled with Toyota part number searching than most dealers are.
Toyota should pay you. how did you find it?
CTScottUSA, CT · Apr 25, 2014#6 Originally Posted by
GrayYaris ↑ Toyota should pay you. how did you find it?
I have copies of the parts catalogs for US, Europe, Japan and General markets. I simply searched for ball joint and then opened the diagram. The clip was shown and clicking on it gives the part number.