The service department still has our car. Called today and was told that the suspension cradle had to be dropped a little more than normal in order to get to the strut (bolts?). Should we be concerned? Also they said that they would check the alignment and only do it if needed. Thanks
Suspension Cradle
20 posts · 8,065 views
Replies 19
Hey what !? What are they talking about ...drop cradle to get bolts for struts u are driving a yaris/ echo ...can't see why u would have to drop the cradle to remove struts .
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Sounds like they went to check the TSB for the A-Arm bolts and had one snap...
They already replaced the two bolts months ago. They said they were having a hard time getting some bolts loose due to corrosion and rust. The car will be there for 4 days as of tomorrow. They are replacing two struts, one rear shock on drivers side and a stabilizer bar link (?). We haven't been told if any of these have been installed, can't get any answers over the phone. Very frustrating.
Sounds like the "B" team must be working on it.
Got the car back and it still crunches from the front and creaks from the back . It now seems be the passenger side rear shock . They replaced the drivers side rear shock due to leaking . Here's a list of what we think was installed for the front .
1.) 2 Absorber Assy, SH
2.) 2 Bearing , Strut MO
3.) 2 Support Sub-Assy.
4.) 2 Support , FR Suspe
5) 4 Nuts
6.) 2 Seat , FR Spring
7.) 2 Bush , Stabilizer ( Repair for Sway Bar Bracket )
These are printouts of specs for the new alignment on 3/28/14 and previous when first brought in 2/24/14 .


1.) 2 Absorber Assy, SH
2.) 2 Bearing , Strut MO
3.) 2 Support Sub-Assy.
4.) 2 Support , FR Suspe
5) 4 Nuts
6.) 2 Seat , FR Spring
7.) 2 Bush , Stabilizer ( Repair for Sway Bar Bracket )
These are printouts of specs for the new alignment on 3/28/14 and previous when first brought in 2/24/14 .



Seriously all the problems you have with vehicles.... Smdh
Sent from my C6902 using Xparent Skyblue Tapatalk 2
Sent from my C6902 using Xparent Skyblue Tapatalk 2
No problem with the '11 Fit at 31,000 + miles (knock on engine block) . We started having issues with the 08 sedan at 20,000+ miles 🙁.Originally Posted by Shroomster ↑Seriously all the problems you have with vehicles.... Smdh
Sent from my C6902 using Xparent Skyblue Tapatalk 2
What would your next step be if your car still creaked / crunched from the front end and possibly the rear after all this work ?
Race Car!
🤣Originally Posted by ilikerice ↑Race Car!
if it is still under warranty document it and bring it to another dealership. And keeping doing that until you get it fixed.
Didn't want to hear that 🙁 .
Took the car for a drive on roads we usually travel and noticed when the steering wheel is level the car pulls to the left . Never had this since new . This is done on level roads . The car also feels like there's more resistance to rolling so have to apply the gas pedal more often . There was very little wind . Last , the crunches and creaks are more frequent and pronounced . May take it to a different shop for an alignment check , some only charge if needed .
We looked at the worksheet and alignment is not listed or charged to TOYOTA . Should be on it as a job performed , yes ? No ? 😕
Yes.Originally Posted by Hershey ↑We looked at the worksheet and alignment is not listed or charged to TOYOTA . Should be on it as a job performed , yes ? No ? 😕
Got the car aligned yesterday , if interested , go here for the results . Alignment specs for a 2008 Yaris sedan . Post # 8 .
What issues could be caused by pulling down the suspension cradle farther than normal ? Would that possibly make the car creak and crunch much more frequent and louder? Or could it be the struts weren't installed properly (bushings) or something else or a combination of all?
That depends on what they left connected to it. If they removed everything than nothing would be stretched. If they left the steering rack attached, then the steering column gets pulled against (as well as the plastic piece that kind of seals the steering column entry) and the end links as well.Originally Posted by Hershey ↑What issues could be caused by pulling down the suspension cradle farther than normal ? Would that possibly make the car creak and crunch much more frequent and louder? Or could it be the struts weren't installed properly (bushings) or something else or a combination of all?
If they left the control arms attached, then they were tugging on the CV joints and risked ripping the boots.
If the left the rear tranny mount attached, then they were yanking against all of the motor mounts.
If they left the sway bar attached, then they yanked against its bushings.
I still don't understand why they dropped the sub frame.
Doubt they'll ever tell us . The service advisor hasn't answered to our messages for 3 days in a row . The rear brakes they lubed and adjusted are squeaking again . The emergency brake fully engages about 3>4 " when pulled up , wasn't like that before , not sure if that's a good thing . Not too pleased with the results . The car gets inspected this weekend and will try to get them to look at the drivers side as part of it . Maybe they'll notice something with the rear brakes . Really appreciate all your input .