My current spoiler cracked over the winter and i don't want to replace it with the same one since they are ABS plastic. I REALLY want the RS or Rally spoiler that was discontinued. Looking for excellent used or dead stock from canadian dealership. Any help would be appreciated and i need this soon since i am looking into repainting the car(clearcoat is peeling)
RS Or Rally spoiler
10 posts · 3,305 views
Replies 9
yep those are the same as the one on my car that cracked. not going to take a chance on another one.
Got a pic of how/where is cracked? I just picked up one of them myself, so before I paint it, if there is an inherent issue, hopefully I can reinforce it.Originally Posted by bladesmith6 ↑yep those are the same as the one on my car that cracked. not going to take a chance on another one.
I will try to get a pic tomorrow. Unfortunately there is no way to reinforce where it cracked, there is a clean split from front to back right down the middle. My opinion is that abs plastic is more brittle and a urethane model should be tougher. The only down side is now if i change spoilers that the holes will be in different places and i will have to plug the old ones.
I am thinking that it might make sense to drill some holes on the surface that mounts against the hatch and foam fill it to give it internal support.Originally Posted by bladesmith6 ↑I will try to get a pic tomorrow. Unfortunately there is no way to reinforce where it cracked, there is a clean split from front to back right down the middle. My opinion is that abs plastic is more brittle and a urethane model should be tougher. The only down side is now if i change spoilers that the holes will be in different places and i will have to plug the old ones.
Here is pic of the damage, really freaky. i don't want to take a chance on another one but the other spoilers all attach far too differently so i guess i dont have much choice. wish i could find the canadian rally spoiler but no one on here will help....
1 attachment not included in this copy
Wow - That's quite a crack. I haven't even primed mine yet, so I think I will foam fill it.
Curious, did you bolt yours down to the car hatch?
I used 3M VHB tape for the whole underside and didn't screw any holes in the hatch. It's been 5 years and haven't had any problems yet.
I think this way allows the spoiler for some expansion/contraction without any tension that might otherwise cause it to crack.
You just have to be sure you install it straight because once it's on, it's (nearly) impossible to readjust.
I used 3M VHB tape for the whole underside and didn't screw any holes in the hatch. It's been 5 years and haven't had any problems yet.
I think this way allows the spoiler for some expansion/contraction without any tension that might otherwise cause it to crack.
You just have to be sure you install it straight because once it's on, it's (nearly) impossible to readjust.
1 attachment not included in this copy
you know i used the bolts and a pro grade adhesive which might have been overkill. i'm thinking that going the 3m tape route might be a better more flexible route as well. now i just have to figure out what to do about the paint job since the clearcoat is peeling....