Yarisworld Archive

Problems installing mud guards

6 posts · 6,845 views

wagoneerOriginal postWisconsin · Apr 20, 2007#1
Ordered a kit from DeLand Toyota in Florida. Kit came, "Made in Canada".

The kit requires 4 clips for the rear mud guards. 2 each side. Kit only came with 2 clips. I went ahead and installed the mud guard without the clips. I will pick some up tomorrow.

Now for the real problem. I read the manual, I know what it says about jacking up the car. I still messed my car up when I did the first wheel.

I jacked it where I thought the manual meant for me to. After that, I threw out the manual and jacked it up "my way" just fine.

Now, questions....does anybody know how much it will cost to "tweak" the front fender 3/4" or so. My two trim pieces under the front of the front passenger door now have a significant gap.😈

Replies 5

ROCKLAND TOYOTAROCKLAND COUNTY NY · Apr 21, 2007#2
looks like your f*cked.....
gonzo452001French Lick,IN · Apr 21, 2007#3
sorry to here that I jacked up my car to rotate the tires jacked the front up at the the little dimple things where the manual says not problem
PetersRedYarisThe Black Hills of South Dakota · Apr 21, 2007#4
Body shops have various shaped clamps that can be clamped on the the seam you pushed up. They can clamp onto it and, using hydraulics, while supporting the rest of the car, pull it back down. It's not that hard to do but I don't know what your problem looks like or the severity. Cost? It's going to vary widely between shops so look around.
uncleyarisToronto · Apr 21, 2007#5
ouch!!!$$ for sure.
wagoneerThread starterWisconsin · Apr 21, 2007#6
Originally Posted by PetersRedYaris ↑
Body shops have various shaped clamps that can be clamped on the the seam you pushed up. They can clamp onto it and, using hydraulics, while supporting the rest of the car, pull it back down. It's not that hard to do but I don't know what your problem looks like or the severity. Cost? It's going to vary widely between shops so look around.
That is what I was hoping to hear. It is just a little tweak. A body panel fitment issue.

I have a hydraulic jack that takes about 5 secs to lift the car. I was using that instead of the manual jack that comes with the car and is under the driver seat.

I picked up the clips I needed today at the auto parts store. Everything is installed properly now.

The panel fit is only out about 3/4", I'm pretty sure I could bend it back myself, but at this point I'm just gonna let someone with experience do it.

I'll inquire at my next oil change. I can live with it till then. Its really not that bad as is.