Yarisworld Archive

New question evap canister replacement

4 posts · 5,943 views

RutherfordOriginal postUnion Mills, NC · Feb 5, 2014#1
Ignore my old thread below as I have updated it.
Bought me a used evap canister and installed it. Thanks so much for the help with the connections. Was not difficult once I knew how to get them apart. After about 180 miles my check engine light came on and I went by Advanced Auto to see what code had come up. It read a small evap leak. I reset it and drove another 300 miles and the check engine came on again, same code P0456 small evap leak. I also still have a problem where I cannot pump gas very fast when I fill it up. It seems like it is not able to relieve the air as quick as I am putting the gas in. When I took the old evap canister off I checked the filter box? in the line from the evap canister to the filler neck. I did not remove it but I disconnected both lines leading into it and attached some tubing so I could blow through from each direction to make sure there was no water in it. I shook it and did not hear anything. Did not see any moisture but it seemed like there was some restriction in it. I figure it may only pass air/fumes in one direction but it was difficult to get air through either way. Could this cause the problem with not being able to pump gas at a normal rate or may I still have an issue with the evap canister? It did pass the emission test here in NC when the light was off👍.

Replies 3

CTScottUSA, CT · Feb 5, 2014#2
The air vent pipe that goes to the filler neck should pass air without a problem in both directions. If is does not, their may be a spider web or something like that partially blocking it.
RutherfordThread starterUnion Mills, NC · Feb 6, 2014#3
Thanks!
Must be a big spider😲Seems like alot of restriction in that little plastic box. I have a real problem with mice but I don't know how he would got in there. The little beggers have chewed every wire on my ignition switch for my kawasaki mule. I finally wrapped the wiring harness with double sided tape coated with black pepper. They don't like that😁Thansk for the help!
CTScottUSA, CT · Feb 6, 2014#4
Originally Posted by Rutherford ↑
Thanks!
Must be a big spider😲Seems like alot of restriction in that little plastic box. I have a real problem with mice but I don't know how he would got in there. The little beggers have chewed every wire on my ignition switch for my kawasaki mule. I finally wrapped the wiring harness with double sided tape coated with black pepper. They don't like that😁Thansk for the help!
Do you park your Yaris outside? While rebuilding my latest Yaris, I figured out exactly how mice can get into a Yaris (nothing to do with the evap system, but a way that they can get into the cabin).