Yarisworld Archive

BACK UP LIGHTS PROBLEMS

12 posts · 17,271 views

jaimicoOriginal postpty · Jan 24, 2014#1
Hello guys, I just notice that my BACK UP lights are not working properly, it does lights up when I put the gear on reverse, but some times turns off, is like something with the switch is loose.

Where is the switch for it? 🤷

My light of temperatura cluster also for the a/c when off some time ago, I installed a new bulb but nothing happend, si it has to be something else, please advise.

Replies 11

CTScottUSA, CT · Jan 24, 2014#2
What year is Yaris and is it an automatic or manual transmission?
jaimicoThread starterpty · Jan 24, 2014#3
2008, sedan, manual
CTScottUSA, CT · Jan 24, 2014#4
Originally Posted by jaimico ↑
2008, sedan, manual
OK. The back-up light switch is located on the top of the tranny. You will need to move the battery out of the way to get at it.

To do a quick and easy test to see if it is actually the problem, you could jump the red wire in pin 3 of connector CA1 to a +12V power source. If the lights come on when you do that, then you know that either the back-up switch is bad or its connector is corroded.

CA1 - MT Back-up Switch.jpg
jaimicoThread starterpty · Jan 24, 2014#5
Thanks a lot, I will check on it!
jaimicoThread starterpty · Jan 26, 2014#6
Yes the lights are ok, so it's got to be the switch or the plug, where do I find them?
CTScottUSA, CT · Jan 26, 2014#7
Originally Posted by jaimico ↑
Yes the lights are ok, so it's got to be the switch or the plug, where do I find them?
In about the most inconvenient location. The sensor is on top of the center of the tranny and the connector in on the back of the tranny:

MT - Back-up Switch.jpg
Geoff PeaceWigan · Jan 26, 2014#8
Originally Posted by jaimico ↑
Yes the lights are ok, so it's got to be the switch or the plug, where do I find them?
Just to add. I would test the switch and connector in situ before going to the trouble of removing it. It may be a corroded connector, a broken wire, or the switch plunger may be stuck, or the switch may need adjusting. Always worth a try to save a few pence!
Regards Geoff Peace.
Mongoose7Liberty NY · Jan 26, 2014#9
Yes, check out the wires coming out of the switch, a mouse ate through one of my backup light switch wires!!!!!!!!
Mike
jaimicoThread starterpty · Jan 26, 2014#10
Well it's nice to know where it is, and yeap, it's going to be a pain to get to it, I'll keep you posted.

Thanks a lot!
7:34pmBritish Columbia · Jan 26, 2017#11
Originally Posted by CTScott ↑
OK. The back-up light switch is located on the top of the tranny. You will need to move the battery out of the way to get at it.

To do a quick and easy test to see if it is actually the problem, you could jump the red wire in pin 3 of connector CA1 to a +12V power source. If the lights come on when you do that, then you know that either the back-up switch is bad or its connector is corroded.

Attachment 52709
Hey I'm having the same problem and trying to figure this out. Both bulbs are good but the reverse lights won't come on.

What exactly is the bottom end of the arrow pointing to? I can't quite tell from the diagram. Also should this be done with the car on or off, or in accessory mode?

Thanks
7:34pmBritish Columbia · Jan 28, 2017#12
Originally Posted by 7:34pm ↑
Hey I'm having the same problem and trying to figure this out. Both bulbs are good but the reverse lights won't come on.

What exactly is the bottom end of the arrow pointing to? I can't quite tell from the diagram. Also should this be done with the car on or off, or in accessory mode?

Thanks
Nvm, just checked and the wire is broken. Going to solder it back or something.