Yarisworld Archive

Check engine light on high revs

8 posts · 6,443 views

jayehOriginal postBritish Columbia, Canada · Jan 22, 2014#1
I found this previous post and was wondering if anyone has any more info since I had this happen to me today. Check engine light flashes during high reving


I was about to merge on to a highway and put my shifter into 2 and floored it and it the car started to accelerate, then around 5k rpm dropped down about 500rpm, flashed the check engine light, I let off and reapplied the gas and it did it again. It happened about 4-5 times along the way too. It was cold out but the car was warmed up.

No codes were shown, no idea what is up. Seems fine on the way home. 🤷

any ideas?

Replies 7

CTScottUSA, CT · Jan 22, 2014#2
Misfires. Either you are due for plugs or you have a coil on the way out. If you have access to a code reader that can read historical as well as current codes you would be able to verify which cylinder the misfire was on.
jayehThread starterBritish Columbia, Canada · Jan 22, 2014#3
Originally Posted by CTScott ↑
Misfires. Either you are due for plugs or you have a coil on the way out. If you have access to a code reader that can read historical as well as current codes you would be able to verify which cylinder the misfire was on.
There were no codes. 🤷

I've got a scan gauge connected.

It was the first thing I checked after I parked.
CTScottUSA, CT · Jan 22, 2014#4
Originally Posted by jayeh ↑
There were no codes. 🤷

I've got a scan gauge connected.

It was the first thing I checked after I parked.
ScanGauge only shows current not historical codes. You would need a more sophisticated reader for that.
jayehThread starterBritish Columbia, Canada · Jan 22, 2014#5
Originally Posted by CTScott ↑
ScanGauge only shows current not historical codes. You would need a more sophisticated reader for that.
What is a current code? It only shows me codes while they happen?

Whats the logic behind the gas cap being loose causing the CEL to stay on, but a misfire doesn't even make it stay on?
CTScottUSA, CT · Jan 22, 2014#6
Originally Posted by jayeh ↑
What is a current code? It only shows me codes while they happen?
Correct. A simple scanner will only show codes when the CEL is on. Smarter tools, like TechStream, show codes that occurred previously, but since have self cleared.
contraband831CEN*CAL · Jan 23, 2014#7
Had this happen to me a few years back and in my case it was the spark plugs, you may want to check them.
jayehThread starterBritish Columbia, Canada · Jan 24, 2014#8
Originally Posted by contraband831 ↑
Had this happen to me a few years back and in my case it was the spark plugs, you may want to check them.
New plugs are on order and they'll be here by the time I have a chance to change them!

Thanks guys.