ShroomsterOriginal postOrlando · Dec 12, 2013#1SIMOTA OIL CATCH CAN INSTALL I put this on MicroImage from my phone. most of us have log-ins over there to view the images....let me know if I need to port this over to here instead of linking to it....
Replies 14
goliath1812Ocala Florida · Dec 12, 2013#2Looks good. I tried a few different catch cans, and could not get my car to run without throwing a CEL. I did not try the Simota. Hope yours works well.
ShroomsterThread starterOrlando · Dec 12, 2013#3Hopefully....
cali yarisCanoga Park, CA · Dec 12, 2013#4Really nicely done, very clean.
MyzticZ3r0Las Vegas, NV · Dec 14, 2013#5clean!
ShroomsterThread starterOrlando · Dec 14, 2013#6 Originally Posted by
goliath1812 ↑ Looks good. I tried a few different catch cans, and could not get my car to run without throwing a CEL. I did not try the Simota. Hope yours works well.
One of two is doing fine. The one on the 2012 is flawless. Mine, the 2014, I keep getting p0171 for lean. Do I have a dud, or does a catch can reading change the vacuum readings that much?
CTScottUSA, CT · Dec 14, 2013#7 Originally Posted by
Shroomster ↑ One of two is doing fine. The one on the 2012 is flawless. Mine, the 2014, I keep getting p0171 for lean. Do I have a dud, or does a catch can reading change the vacuum readings that much?
You must have a leak. If everything is sealed it should not have an effect like that.
ShroomsterThread starterOrlando · Dec 15, 2013#8Yeah, is weird as everything is tight. I don't have a smoke machine to check for leaks, but I still suspect that the pcv nipple being able to slip out of the silicone tube even with the hose clamp tightened is the culprit, yet I now have two clamps on it and a spacer between the tube and clamp.... Maybe a smaller diameter tube is in order....
ShroomsterThread starterOrlando · Dec 15, 2013#9I'm hoping I found the leak. The breather tube from cc to intake had oil seepage around large nipple on air intake, it was clean yesterday. Where there's fluid there's going to be an air leak....
ShroomsterThread starterOrlando · Dec 15, 2013#10No go still.... waiting on wife to bring home PTFE tape... Going to remove inlet & outlet ports and apply the tape, also to drain plug.... Here's to going it works....
CTScottUSA, CT · Dec 15, 2013#11How is the can constructed? Does it have an inner plastic container or is the the sight window bonded to the aluminum?
ShroomsterThread starterOrlando · Dec 15, 2013#12Looks to be sealed, dual windows on aluminum.....
CTScottUSA, CT · Dec 15, 2013#13 Originally Posted by
Shroomster ↑ Looks to be sealed, dual windows on aluminum.....
That might be worth testing as well. Stick a finger over the two fittings and hold it under water and look for bubbles.
ShroomsterThread starterOrlando · Dec 16, 2013#14Yeah, testing of the unit will come today.... I added PTFE to the three ports... The code hasn't popped yet, but it is showing as pending if I'm reading the code reader correctly.
ShroomsterThread starterOrlando · Dec 22, 2013#15Alright, I found the leak.... It's coming from the lower shiny end cap where it mates to the main cylinder.... I'll post a pic in a few....
Picture lost · img.tapatalk.com