Replies continued
Ryze268Thread starterAntigua & Barbuda · Nov 14, 2014#51 Originally Posted by
KTS ↑ Don't give up. you will definitely enjoy it in the end when it is working great. Trial and error is all part of it. all settings for fuel and ignition should be at zero but in your case with the larger injectors try setting fuel at 3k rpm a little negative. How many resistors you added?
1 2.2k resistor per connection. Everything is zero'd
If the ecu can rev just fine with the bypass harness, shouldn't it rev just fine with the fic zero'd?
Now I'm starting to think I have a bad fic 😢
KTSTrinidad and Tobago · Nov 14, 2014#52try adding a second resistor....then a third and see if it improves.
Just saying from past experiences with another vehicle I got no improvement after one resistor, nor two, nor three, it was successful after 4four resistors. Its worth a try for you too. the resistors are cheap and easy to connect.
Ryze268Thread starterAntigua & Barbuda · Nov 14, 2014#53I'm waiting on CTScott to reply. i believe it's wired in wrong.
Ryze268Thread starterAntigua & Barbuda · Nov 15, 2014#54Wiring is correct, disconnected the CAM and CRK wires same issue occurs, would flooding the engine with fuel cause it to not rev?
BoostedTRDVA · Nov 17, 2014#55 Originally Posted by
Ryze268 ↑ Wiring is correct, disconnected the CAM and CRK wires same issue occurs, would flooding the engine with fuel cause it to not rev?
have you removed your spark plugs and checked them?