Yarisworld Archive

rear beam question: one wheels sticks out more

59 posts · 17,611 views · page 2 of 2

Replies continued

sasquatchbuffalo, NY · May 10, 2014#51
Originally Posted by CTScott ↑
OK. In that case the cut/weld is the way to go. You have about 1/2" to play with before you have to remount the shock mount.

That's what I was gonna ask about haha. So 1/2 inch total or 1/2 inch on each side can be removed. if that makes sense.
CTScottUSA, CT · May 10, 2014#52
Originally Posted by sasquatch ↑
That's what I was gonna ask about haha. So 1/2 inch total or 1/2 inch on each side can be removed. if that makes sense.
!/2" per side. You could get almost 1.5" per side if you cut right up to the shock mount.
sasquatchbuffalo, NY · May 10, 2014#53
I am now intrigued. Will have to look into this more
kimonaHuntington Bch, CA · May 10, 2014#54
Same problem up front as discussed a long time ago in another thread somewhere.
sasquatchbuffalo, NY · May 10, 2014#55
Picture not included in this copy

This isn't her beam. But basically carefully cut the hub mount bracket off and move it in and reweld it should pull the wheel in more?
CTScottUSA, CT · May 10, 2014#56
That's not a 2nd gen Yaris one, but the pic below is. The one tricky thing is that you want to cut out a section to move it in, but at the same time you need to maintain the distance from the pivot point or the wheel will no longer be centered forward to back.



Picture not included in this copy

1 attachment not included in this copy

DINOeggxoThread starterBuffalo, NY · May 10, 2014#57
Originally Posted by CTScott ↑
That's not a 2nd gen Yaris one, but the pic below is. The one tricky thing is that you want to cut out a section to move it in, but at the same time you need to maintain the distance from the pivot point or the wheel will no longer be centered forward to back.



Attachment 53490
ahhhhhh i see, i blame google for the wrong image haha. we will have to get under the car and take a look at what kind of room i'm looking at and what area would be best to remove material from. Then speak with a friend who does fabrication work and see about what could be done. not going to give up yet!
ExiwolfmanWasaga beach · May 10, 2014#58
now that i have read this think im gone save my hub spacers for the next Yaris ...any idea if this problem is on 2012 up ?
CTScottUSA, CT · May 10, 2014#59
Originally Posted by DINOeggxo ↑
ahhhhhh i see, i blame google for the wrong image haha. we will have to get under the car and take a look at what kind of room i'm looking at and what area would be best to remove material from. Then speak with a friend who does fabrication work and see about what could be done. not going to give up yet!
It is definitely a cool idea. I had a spare beam that would have been perfect for you to experiment with, but unfortunately someone else grabbed it to replace a bent one.