Yarisworld Archive

DIY - Exterior lights on when doors are remotely unlocked

21 posts · 62,991 views

CTScottOriginal postUSA, CT · Jun 11, 2013#1
The dome light on the Yaris comes on when the doors are unlocked, so using a relay one can drive the headlights, parking lights or fog lights from the dome light feed, so that they illuminate when remotely unlocking the car.

Note that since the dome also comes on when simply opening the door, the exterior lights connected using this DIY will come on when opening the doors as well.

Materials required:

1. Automotive type relay
2. Relay socket or 5x 1/4" female spade terminals (and wire)
3. 4x 24-18 AWG tap splices
4. 1x 1/4" ring terminal

In the picture below, the top relay is shown with a relay socket and the bottom relay is shown with 1/4" female spade terminals.

Relays.jpg


The terminals on a "standard" automotive relay are labeled as 85, 86, 87, 87A, and 30.


For 2006-2011 Yaris:

Attached picture not available



Relay pin 85: Connect to Light Blue wire on dome light connector (in the first picture)
Relay pin 86: Connect to Pink wire on dome light connector (in the first picture)

Headlights on when unlocking:
Relay pin 30: Connect to the light blue wire, next to the pink wire
Relay pin 87: Connect to the white/black wire, next to the light blue wire


Parking lights on when unlocking:
Relay pin 30: Connect to the white wire in position 13 (in the second picture)
Relay pin 87: Connect to the wire three wires over to the right from the position 13 wire. It will either be white/black or green.


Fog Lights on when unlocking:
Relay pin 30: Connect to chassis ground (easiest way is using a ring terminal installed under a bolt that goes into the metal of the dashboard support frame).
Relay pin 87: Connect to the Yellow wire on the headlight switch connector. (in the second picture)


For 2012-2013 Yaris:

This is the body ECU, under the left side of the dash. The connector on the top right is D143. The connector on the top left is 3D and the one of the bottom right is 3C. Connectors 3A and 3B are on the back side of that white plastic box.

Picture lost · i372.photobucket.com


Picture lost · i372.photobucket.com

Picture lost · i372.photobucket.com

Picture lost · i372.photobucket.com

Picture lost · i372.photobucket.com


This is the headlight switch connector (D106):

Picture lost · i1089.photobucket.com

Picture lost · i372.photobucket.com


Relay pin 85: Connect to Sky Blue wire in pin 5 of connector 3A

Relay pin 86: Connect to Black wire in pin 6 of connector 3B

Headlights on when unlocking:
Relay pin 30: Connect to the wire in pin 20 of the headlight switch connector (in the picture above it is the green wire on the top right, but the color can be green black or light blue)
Relay pin 87: Connect to the white/black wire in pin 12 of the headlight switch connector (in the picture above it is to the right of the red wire)

Parking lights on when unlocking:
Relay pin 30: Connect to the sky blue wire in pin 18 of the headlight switch connector (in the picture above it is to the left of the green wire on the top right)
Relay pin 87: Connect to the white/black wire in pin 12 of the headlight switch connector (in the picture above it is to the right of the red wire)

On the 2012-2013, the fog light wiring is not accessible to allow them to be wired to be on with the ignition off.

Replies 20

CrankyOldManWest Michigan · Jun 11, 2013#2
I'm not sure where you find the time for this stuff, but it's great to have!

The first attachment seems to be broken though...
CTScottThread starterUSA, CT · Jun 11, 2013#3
Originally Posted by CrankyOldMan ↑
I'm not sure where you find the time for this stuff, but it's great to have!

The first attachment seems to be broken though...
Fixed - Thanks.
skoyaBosnia,Sa · Jun 13, 2013#4
Great!!!

But I'm not sure is that the same wire colour for the parking lights on the second picture with the european models.
CTScottThread starterUSA, CT · Jun 13, 2013#5
Originally Posted by skoya ↑
Great!!!

But I'm not sure is that the same wire colour for the parking lights on the second picture with the european models.
You are correct - The European Yaris does have some different colors for some of the wiring.
skoyaBosnia,Sa · Jun 14, 2013#6
Can you find out which colour is for the parking lights,cause I want to switch it from headlights.
jcboyAsia · Jun 14, 2013#7
Scott, if I were in CT and you were a lady, i wouldve kissed you for this. LOL

Seriously, great writeup! i'm so doing this. :)

T H A N K Y O U :D

curious question though, (since im doing the parklights), this shouldnt cause any issues with the way the parklights work right now or anything else for that matter, should it?

thanks again.
toy_torontoTarrana, Canada · Jun 14, 2013#8
Originally Posted by jcboy ↑
.
curious question though, (since im doing the parklights), this shouldnt cause any issues with the way the parklights work right now or anything else for that matter, should it?

thanks again.

This is like asking Chef Ramsay if he knows how to prepare a Risotto ...
jcboyAsia · Jun 15, 2013#9
Correction scott, you got a typo.

For parklights pins 13 and 10 should be relay 30 and 87,respectively.
jcboyAsia · Jun 15, 2013#10
Originally Posted by toy_toronto ↑
This is like asking Chef Ramsay if he knows how to prepare a Risotto ...
Good point. I was just thinking out loud lol 🙄
CTScottThread starterUSA, CT · Jun 17, 2013#11
Originally Posted by skoya ↑
Can you find out which colour is for the parking lights,cause I want to switch it from headlights.
For your European Yaris, it will actually be the same as for the US Yaris. I had a typo in that section for the 2006-2011, which is now fixed.
nookandcrannycarS.MontgomeryCnty,TX(HoustonMSA) '07=BayouBlue=300,125miles=OrigOwnr '14=ClassicSilvr=29,059miles · Jun 17, 2013#12
Just out of curiosity and looking into the future (IDK, this may be an eye roller of a question re lameness --- I don't have power locks nor keyless entry on my Yaris), would the setting on the dome light have any effect on the lights controlled by this DIY? In other words, would setting the dome light to off (one of the 3 settings on the 1st gen USDM Yaris) keep the dome light (and the lights related to it re the DIY) off when utilizing the keyless entry?
jcboyAsia · Jun 17, 2013#13
Originally Posted by nookandcrannycar ↑
Just out of curiosity and looking into the future (IDK, this may be an eye roller of a question re lameness --- I don't have power locks nor keyless entry on my Yaris), would the setting on the dome light have any effect on the lights controlled by this DIY? In other words, would setting the dome light to off (one of the 3 settings on the 1st gen USDM Yaris) keep the dome light (and the lights related to it re the DIY) off when utilizing the keyless entry?
no it doesnt, as the switch on the domelight doesnt affect the current passing through the pink/blue wires in the underdash junction box. this switch only affects whether or not to use that electricity to turn the domelights on.
nookandcrannycarS.MontgomeryCnty,TX(HoustonMSA) '07=BayouBlue=300,125miles=OrigOwnr '14=ClassicSilvr=29,059miles · Jun 18, 2013#14
Originally Posted by jcboy ↑
no it doesnt, as the switch on the domelight doesnt affect the current passing through the pink/blue wires in the underdash junction box. this switch only affects whether or not to use that electricity to turn the domelights on.
👍 Thanks.
jcboyAsia · Jun 18, 2013#15
Originally Posted by nookandcrannycar ↑
👍 Thanks.
glad to help. 🙂 TBH, i actually did it, partly because I was curious about the same thing you asked. the only part I don't like now is that it also activates when you open the door, say, someone gets off the car, since it is connected to the domelights, rather than the alarm signal itself.

hi Scott, anyway we can tap it to the TVSS module instead, so that this process of activating the parklights/headlights/FLs doesnt get triggered by the door? 😕
CTScottThread starterUSA, CT · Jun 18, 2013#16
Originally Posted by jcboy ↑
glad to help. 🙂 TBH, i actually did it, partly because I was curious about the same thing you asked. the only part I don't like now is that it also activates when you open the door, say, someone gets off the car, since it is connected to the domelights, rather than the alarm signal itself.

hi Scott, anyway we can tap it to the TVSS module instead, so that this process of activating the parklights/headlights/FLs doesnt get triggered by the door? 😕
If you have the TVSS (security system) you could do so, but most Yaris over here do not.
yours_falselyIndiana · Sep 10, 2013#17
Inversely, what would one have to do in order to have the headlights turn off when the car is locked?
CTScottThread starterUSA, CT · Sep 10, 2013#18
Originally Posted by yours_falsely ↑
Inversely, what would one have to do in order to have the headlights turn off when the car is locked?

My headlights off with the ignition DIY is the easiest way to get close to that:

DIY - Headlights off with the Ignition Switch
CTScottThread starterUSA, CT · Dec 30, 2013#19
Originally Posted by toyota86 ↑
Hi CTscot

I really like your post. Could you help me do the same thing but with a Toyota 86?

Here is the wiring diagram http://www.ft86club.com/files/BRZwiringi.pdf

I had a look at the Yaris diagram and it is similar but would really like some help.

Thank you!
The 86 is very different. The Body ECU has control over the lights.

You could try grounding the white wire in pin 20 of the headlight switch. If that works for making the headlights come on with the car off, then you would connect one contact terminal (30) of the relay to that wire and the other (87) to ground.

You would then connect pin 17 of body ECU connector D5 to the relay coil terminal 85 and terminal 86 of the relay coil to the dome light positive wire (it doesn't look like there is a simple connector for grabbing that wire, so you would have to find one of the orange or light green wires on page 184/185.)
denniskthe Netherlands · Jan 4, 2025#20
Hi, sorry to bring up an old thread.

I want to do this in my 2014 Yaris (facelift) Europian. Is the wiring the same as in the 2012-2013 version?
And if so, where is D106 located? That image seems to be unavailable.
denniskthe Netherlands · Jul 31, 2025#21
So I found the D106, it's the connector of the headlight switch behind the panels at the steering wheel.

It works perfectly, however by default the car makes a beep sound when the lights are on, the car is off and the doors are open. With this mod, the car now always does this when I open a door. I would prefer this not to happen when the switch is in the "off" position.
Did anyone else run into this issue as well? And can this somehow be resolved?
My car does not have automatic headlights btw.