Yarisworld Archive

Putting on dust cover boot ring on ball joint

11 posts · 10,776 views

yaris4062007Original postnorthern california · Apr 21, 2013#1
Is there special tool to install dust boot cover ring on ball joint?
image.jpg

Replies 10

yaris4062007Thread starternorthern california · Apr 21, 2013#2
:(
image.jpg
yaris4062007Thread starternorthern california · Apr 21, 2013#3
This happened after using ball joint fork 😲
image.jpg
yaris4062007Thread starternorthern california · Apr 21, 2013#4
.
image.jpg
CTScottUSA, CT · Apr 21, 2013#5
Did you rip the new boot by trying to use the for to get that ring on?

I would probably try two pairs of locking pliers to hold the ends while pulling them apart to get the clip into place. There is a special tool for spreading that type of clip, but it may not be something that you could get from a local autoparts store.
B2FiNiTYUS · Apr 21, 2013#6
What Scott said. There are some special pliers. I've gotten them from sears before. Craftsman.
YarisSedanCalifornia - Bay Area · Apr 21, 2013#7
I hate using pickle forks on the ball joint it always garentees you will damage the boot. This is the actual tool and brand I keep in my tool box for this job

http://www.youtube.com/watch?v=7vweCmGwBiU

Its about 20 bucks at harbor freight or around 50 for the entire master kit.
yaris4062007Thread starternorthern california · Apr 21, 2013#8
No, that's old stock boot and new one still good. I tried to spread using two locking pliers but it doesn't spread enough to fit. Looks like i need special tool
yaris4062007Thread starternorthern california · Apr 21, 2013#9
You got any picture what it looks like .
Originally Posted by B2FiNiTY ↑
What Scott said. There are some special pliers. I've gotten them from sears before. Craftsman.
yaris4062007Thread starternorthern california · Apr 21, 2013#10
Yep I used that to remove it after fork failed
Originally Posted by YarisSedan ↑
I hate using pickle forks on the ball joint it always garentees you will damage the boot. This is the actual tool and brand I keep in my tool box for this job

http://www.youtube.com/watch?v=7vweCmGwBiU

Its about 20 bucks at harbor freight or around 50 for the entire master kit.
yaris4062007Thread starternorthern california · Apr 21, 2013#11
Can I use this to lubricate ball joint?? Thank you
image.jpg