Yarisworld Archive

PCV valve over tight

9 posts · 8,233 views

peewee1Original postNew York · Apr 6, 2013#1
My pcv valve is sooooo tight i'm afraid I'm going to "tear" or damage it when trying to remove it. All I've tried is the 3/8 ratchet and socket. I thought the engine was going to be pulled out when I tried to loosen the valve. Could I use maybe some penetrating oil, or "heat" from a torch? This s.o.b. is !!!! Thanks for any ideas.......

Replies 8

Yaris_80Florida · Apr 6, 2013#2
I just changed mine as well, At first I used a 3/8 ratchet and it felt like it was welded on. Step it up to a 1/2 ratchet with a deep wall socket and it'll be easier.
peewee1Thread starterNew York · Apr 6, 2013#3
I took your advise with 1/2 inch ratchet,Plus a nice steel pipe as a breaker bar, I heard a nice snap and it loosened up. Cleaned it out with gunk and reinstalled it. Thanks for the help.
Hersheynortheast · Apr 7, 2013#4
Checked it for the sedan . Had oil in it . Still hear the rattle from within , so placed it back in . Should it be cleaned or recheck later ?
peewee1Thread starterNew York · Apr 9, 2013#5
While you have it out why not clean it with a little Gunk.
Hersheynortheast · Apr 9, 2013#6
Don't have any .
UberSilverAlameda,Ca. · Apr 9, 2013#7
Originally Posted by peewee1 ↑
My pcv valve is sooooo tight i'm afraid I'm going to "tear" or damage it when trying to remove it. All I've tried is the 3/8 ratchet and socket. I thought the engine was going to be pulled out when I tried to loosen the valve. Could I use maybe some penetrating oil, or "heat" from a torch? This s.o.b. is !!!! Thanks for any ideas.......
Dont remove it. Next time you change your oil, spray a bunch of wd-40 in the pcv(before the oil change), and that should clean it just fine.
junorico24Sydney · Aug 31, 2013#8
Mine came off easier than i thought. I checked it and didn't see any build up at all.Did the shake test and it was rattling fine inside.But decided to give it clean up with carb cleaner. I also did the throttle body.


Maybe your turning it the wrong way?
esse10richmond TX. · Sep 1, 2013#9
Since you have it off now put some anti-sieze on the threads for next time. Not too much just a little dib on the threads and I guarantee it'll come out real easy a year from now.