Planning on getting an exhaust for my Yaris. I'm interested in the Tanabe Medallion Touring Exhaust but i'm worried that it sits a little low. http://www.youtube.com/watch?v=ROeri4U66ic this guy had it set up like this. Has anyone else have it set up like that and does it scrape the road a lot? Thanks Everyone.
Tanabe Medallion Touring Exhaust
18 posts · 7,692 views
Replies 17
sweet thank you for the advice!
No scraping issues with mine, lowered 1.5" on Megan springs. It really dosen't hang much lower than the stock pumpkin. Also, there is not a lot of room to raise it with shorter hangers. The tip sits pretty close to the bumper on stock hangers.
I have a trd hanging pretty low on my sedan and Im slammed low and have never had rubbing, you should be good
I don't know what you mean by this. There is only one way to install it. You cannot rotate it so that the can lies in a horizontal position. Is that what you mean?Originally Posted by DJYojimbo ↑this guy had it set up like this. Has anyone else have it set up like that...
http://www.youtube.com/watch?v=ROeri4U66ic this guy had it set up like this.That's the way it goes.
Ugh. I wouldn't rev my engine like that when it's cold...
To respond to OP, I think the muffler just looks low because of the angle from which the video is being recorded. The tip of the Tanabe is not that much lower than the stock muffler's tip and only because it is a 4" tip. You can't see the bumper in the video but the tip is right up next to the bumper's bottom.
To respond to OP, I think the muffler just looks low because of the angle from which the video is being recorded. The tip of the Tanabe is not that much lower than the stock muffler's tip and only because it is a 4" tip. You can't see the bumper in the video but the tip is right up next to the bumper's bottom.
Yes I didn't know if that vertical position is the only way to set it up. Btw I have the 2012 SE and gonna save up for this exhaust thank you everyone
My sentiments exactly.Originally Posted by Yaristeve ↑Ugh. I wouldn't rev my engine like that when it's cold...
Greg
Will this fit the 2012 SE?
Yes it should work just fine with the 2012.
Thanks Garm gotta save up!
@DJYojimbo, I've ordered mine today and will receive it by next week... I'll install it on my 2008 yaris HB and will tell you if its too low ! Should fit on 2012 tho..
@TrYaris Thank You! Hope it works out! The youtube videos look really good that i want to buy one right now but can't afford it right now haha!
Sorry to revive an old thread, but has anybody been slammed with this exhaust and experienced scraping"? I am talking about 16 inch wheels sitting flush with the fender low.
I'm not "slammed" but I have this exhaust with TEIN's stech that gives me a 2 inch drop and I have scraped it but it's not as bad as you may think, it's been like two or three times and it happened because I quickly accelerated after going through a speed bump and the rear of the car was still going trough the speed bump, so the suspension had to travel more thus causing the exhaust to mildly scrape with the speed bump. Hope that makes senseOriginally Posted by Supra_Yaris ↑Sorry to revive an old thread, but has anybody been slammed with this exhaust and experienced scraping"? I am talking about 16 inch wheels sitting flush with the fender low.
Are you still using the OEM exhaust header? After I installed my weapon r header, my Tanabe Touring is sitting higher/closer to the rear bumper than before. That should also help with scraping.