Yarisworld Archive

Is there anyway to fix this?

10 posts · 3,761 views

caineroadOriginal postToronto · Aug 9, 2012#1
Picture not included in this copy

Replies 9

ajmarshall169myrtle beach · Aug 9, 2012#2
sand it down and paint over it. same thing happen to my old car.
BEEFnorth carolina · Aug 9, 2012#3
you could repaint it or just replace the whole thing.

right below the section in question, there s a small plastic insert that is covering the nut which holds it to the stud. just remove the plastic insert and take the nut off. the wiper comes right off. the wiper is ribbed (there is a propper word for it but it eludes me) so that it will turn with the movement of it.

I actually used the dirt on my windshield for alignment when I removed mine. I had to remove my cowl for spring removal.

good luck regardless of what you decide to do.
WeeYariGeorgetown, Ontario, Canada · Aug 9, 2012#4
I was lucky enough to obtain a new set of pristine arms at a wrecking yard a few years back. I use my old corroded ones in the winter, and switch to the second good set in the summer.
LuxMarkham, Ontario, Canada · Aug 9, 2012#5
Corrosion on the surface could mean corrosion on the splines beneath it which attach the arms to the motor. Don't bother playing doctor dress-up and just replace the arm altogether.
Originally Posted by BEEF ↑
the wiper is ribbed (there is a propper word for it but it eludes me)
Splined 👍
BEEFnorth carolina · Aug 9, 2012#6
splined, there we go. was a bit brain dead earlier today. it happens.
yarisugiハワイ · Aug 9, 2012#7
^brain was thinking "condoms". 😆
bronsinnj · Aug 9, 2012#8
How did that happen? 🤷

Personally I dont worry about things like that unless I have nothing better to do someday.
WeeYariGeorgetown, Ontario, Canada · Aug 9, 2012#9
Originally Posted by Lux ↑
Corrosion on the surface could mean corrosion on the splines beneath it which attach the arms to the motor. Don't bother playing doctor dress-up and just replace the arm altogether.
WTF are you talking about!? I have never seen spline corrosion on any wiper arm that exhibits this common problem of paint blistering on this part of the arm.
CrankyOldManWest Michigan · Aug 9, 2012#10
Based on the location of the blistering, it's not from the spline. The spline is under the cap, all the way on the right of the arm. This looks like a flaw in the finish around the pivot pin, possibly caused by mechanical damage (ice scraper, "snapping" them down too hard, rock chip, etc.) I'd say just get a new/salvaged one.