Yarisworld Archive

"RS" BADGE

7 posts · 3,734 views

chung_77Original postIrvine, CA · Jul 20, 2012#1
I have a 2009 Yaris S and my friend in Japan bought me an "RS" emblem for my front grill. I tried to fit it, but it won't go on the grill. Does anyone out there know if I have to tweak the brackets to make it fit or there is no way to put it on the U.S. version? Please let me know. I already have the Vitz emblem on. Thanks for the help in advance.

Replies 6

cali yarisCanoga Park, CA · Jul 20, 2012#2
^ you have to snip the tabs and use double-sided tape to apply it to a USDM grill.
chung_77Thread starterIrvine, CA · Jul 20, 2012#3
So should I flatten the emblem? Sand it down and put super sticky adhesive tape on the back? Is that the only way? Thanks a lot for the help.
cali yarisCanoga Park, CA · Jul 20, 2012#4
^ Yes, that is what I was describing. And it's the only way that I know of. And don't worry, with good tape, that will NOT come off. 🙂

The tabs just don't match our grill pattern.
kimonaHuntington Bch, CA · Jul 20, 2012#5
I didn't use 2 sided tape. I used a self-threading screw and large washer for that round tab with hole. Then, I shaved off all the other tabs except one... which I discovered actually fit into the grille opening nicely. The emblem is perfectly positioned and very secure.

1 attachment not included in this copy

chung_77Thread starterIrvine, CA · Jul 20, 2012#6
Thanks for all your help. By the way, the back of my RS emblem does not look like that. It has three prongs on the right, left and middle and then so a thick prong at the bottom. It looks weird, but it looks like it will fit if I take off some of the extra prongs. Thanks again.
chung_77Thread starterIrvine, CA · Jul 21, 2012#7
Originally Posted by kimona ↑
I didn't use 2 sided tape. I used a self-threading screw and large washer for that round tab with hole. Then, I shaved off all the other tabs except one... which I discovered actually fit into the grille opening nicely. The emblem is perfectly positioned and very secure.
My emblem does not have the hole for a screw in the back. I have an 09 RS badge which is a little different than the 07 badge. The front grills were different those years.