So yesterday I went back down to Granite State Dyno and Tune ( http://granite-state-dyno.com/ ) with Tiamat with the new setup. Major changes even if they do not impact on the dyno are as follows from my previous dyno pulls referenced ( http://www.microimageonline.com/foru...ll=1#post61914 ) :
- NST Cage Bushings and engine compartment linkage bushings
- NST in cabin short shifter
- Micro Image shifter linkage bracket
- Micro Image silicone radiator hose set
- Autometer Fuel Pressure Gauge kit
- CCI Lightweight Flywheel
- CCI Stage 3 clutch kit
- Tial MV-S External Wastegate
- Grimmspeed Universal Manual Boost Controller
- ARP Exhaust Manifold Bolts
- Changed all fluids to AMSOIL
- Might be more, but it escapes me for now
- Running XXR 508s with Diamondback 225/4018s (previously 15" steelies with 195/60/15s)
- Ambient temp ~95 degrees F and 22% himidity (previously ~80 degrees F and 5% humidity)
All in all I am happy. The new motor seems to be running really solid however I need to figure out why I am throwing a P0335 when we have already resolved the wiring issue with my Boomslang before the previous pulls. My tuner and I think that is the reason why I can't maintain a solid idle. Even with the motor/turbo heatsoaked like a mofo from the 7 hr drive down I still pulled a 168hp/164tq which is only a few off from my previous attempts. The big thing here however is that even though it is synthetic we were able to figure out that with a stock motor the top speed is roughly at 146mph. This is when we hit the rev limiter and the car would do what it of course does.
Picture not included in this copy
Video:
Picture not included in this copy
Video:
Picture not included in this copy
Picture not included in this copy
Picture not included in this copy
and for grins this is the car that was on the dyno before me:
Picture not included in this copy
- NST Cage Bushings and engine compartment linkage bushings
- NST in cabin short shifter
- Micro Image shifter linkage bracket
- Micro Image silicone radiator hose set
- Autometer Fuel Pressure Gauge kit
- CCI Lightweight Flywheel
- CCI Stage 3 clutch kit
- Tial MV-S External Wastegate
- Grimmspeed Universal Manual Boost Controller
- ARP Exhaust Manifold Bolts
- Changed all fluids to AMSOIL
- Might be more, but it escapes me for now
- Running XXR 508s with Diamondback 225/4018s (previously 15" steelies with 195/60/15s)
- Ambient temp ~95 degrees F and 22% himidity (previously ~80 degrees F and 5% humidity)
All in all I am happy. The new motor seems to be running really solid however I need to figure out why I am throwing a P0335 when we have already resolved the wiring issue with my Boomslang before the previous pulls. My tuner and I think that is the reason why I can't maintain a solid idle. Even with the motor/turbo heatsoaked like a mofo from the 7 hr drive down I still pulled a 168hp/164tq which is only a few off from my previous attempts. The big thing here however is that even though it is synthetic we were able to figure out that with a stock motor the top speed is roughly at 146mph. This is when we hit the rev limiter and the car would do what it of course does.
Picture not included in this copy
Video:
Picture not included in this copy
Video:
Picture not included in this copy
Picture not included in this copy
Picture not included in this copy
and for grins this is the car that was on the dyno before me:
Picture not included in this copy