I have a 2007 LB. I am looking to lower it. It has 74 thousand KM on the clock.Stock suspension seems ok, however it's high up the ground. Time to drop it low. It's daily driver.I have on 15 x 6.5 rims.
Any suggestions?
Any suggestions?
39 posts · 12,809 views
I haven't decided yet.It's a daily driver. Bro give me the pros and cons on both.Originally Posted by 1.5 ↑springs or coilovers depending how low you want. If you want springs, once my megan coilovers are on I will be selling my ksport springs.
SOLD!Originally Posted by thebarber ↑i had megan coilovers, too. very firm for a daily driver
ive also used eibach prokits, i currently have eibach sportlines. ive also been in a couple yarii with megan springs....much more comfortable
ive been in crandalls yaris with tein basic coilovers and found them too soft....i have h-tech on my vibe and they are oem comfy, but oem soft
i love my progressive rate eibachs....id run tokico's and eibachs....i never really mess with the height once its set
i got the same tire as you want (205/40/17). mine is Nitto tires (Japan). I got a problem because my G-games wheel has +40 offset, the rear tires are rubbing on the fender when Im fully loaded even in a small uneven surface...Im planning to change my wheels sooner or later🤷Originally Posted by ruvios ↑hey guys. what about wheels on 205/40/17? what is the best thing for this kind of tire?
planning to get Tein S-Tech with a 1.5 drop. what do you think? need a 1 to a tight 1 finger gap.
thanks.
Rubbing with +40 offset? Only time I started rubbing was when I had 17x7.5, ET28 with 205/40/17 tires. Rolled the rear fenders, and rubbing went away. Now I'm on 17x8, ET32 in the back, and no rubbing.Originally Posted by xtremist ↑i got the same tire as you want (205/40/17). mine is Nitto tires (Japan). I got a problem because my G-games wheel has +40 offset, the rear tires are rubbing on the fender when Im fully loaded even in a small uneven surface...Im planning to change my wheels sooner or later🤷
ya, that's why i need to check again, the funny thing is that Im not the one having this same prob. one of my friend also having the same specs of the tire and the most of the rubbing is only on the right rear tire. he just put a stopper on his spring and the rubbing is gone during uneven surface.😕Originally Posted by Kaotic Lazagna ↑Rubbing with +40 offset? Only time I started rubbing was when I had 17x7.5, ET28 with 205/40/17 tires. Rolled the rear fenders, and rubbing went away. Now I'm on 17x8, ET32 in the back, and no rubbing.
Originally Posted by xtremist ↑ya, that's why i need to check again, the funny thing is that Im not the one having this same prob. one of my friend also having the same specs of the tire and the most of the rubbing is only on the right rear tire. he just put a stopper on his spring and the rubbing is gone during uneven surface.😕
thanks bro...Originally Posted by 1.5 ↑That is odd that you are rubbing on that set up. On 8" wide wheel, +20 on 195s I barely rubbed. I was pm 15s but my fender gap is non existant so I should be rubbing a lot more than you if you're rubbing already.
I did have the same thing you describe where only my rear driver tire rubbed which was caused by the seating postion combined with the lower spring rate in the rear.
Try rolling/pulling the fenders
Mind taking some closer pics of your wheel/tire and fender? Shouldn't be rubbing too badly (if at all) with +40 unless your rims are super wide.Originally Posted by xtremist ↑ya, that's why i need to check again, the funny thing is that Im not the one having this same prob. one of my friend also having the same specs of the tire and the most of the rubbing is only on the right rear tire. he just put a stopper on his spring and the rubbing is gone during uneven surface.😕
Because your have a sub woofer at the back. That's why, IMO.Originally Posted by Mz3oh5 ↑Y does my car lag when I turn fast corners? Will my lowering springs have any affect once I get them installed? Any advice?
what do you mean by lag can you expound on this?Originally Posted by Mz3oh5 ↑Y does my car lag when I turn fast corners? Will my lowering springs have any affect once I get them installed? Any advice?
Stiffer springs would help some, but a sway bar would help a LOT. 👍Originally Posted by Mz3oh5 ↑Junorico24 thank your for your opinion, 1.5 (located in Tampa) I like your FB page maybe because I was born & raised in Miami :)
It drifts a little on a side like on sharp right turns. I have to break continuously before I turn instead of turning and keeping my momentum. Will a rear sway bar make any improvements?
yes and thank youOriginally Posted by Mz3oh5 ↑Junorico24 thank your for your opinion, 1.5 (located in Tampa) I like your FB page maybe because I was born & raised in Miami :)
It drifts a little on a side like on sharp right turns. I have to break continuously before I turn instead of turning and keeping my momentum. Will a rear sway bar make any improvements?
this ^^ and dampers other torsion beams like sway/room bars/x braces/under body bracing/tires/wider wheel base from spacers... might be more too, lowering the car will lower the center of gravity and reduce body roll tooOriginally Posted by D&D ↑Stiffer springs would help some, but a sway bar would help a LOT. 👍
Dealer ship will charge $$$ due to the fact that they have higher overhead cost. Besides, it's just springs. You can probably do it on your own if you have the proper tools. What made you go with Teins? Add some chassis parts and you'll have less body roll and it'll help a small car like a Yaris.Originally Posted by Mz3oh5 ↑THANK YOU ALL FOR YOUR ADVICE. I feel better communicating with individuals who understand & drive my car.
I should stop driving fast, but I cant help it. I think im going to start with installing a TRD Rear Sway Bar which should be easy considering it has 4 bolts. I finally found a place who can install my TEIN Lowering Springs if anyone is interested I can show you a picture of how my car looks like before & after (in the future).
**BTW dont call Toyota dealership to install lowering springs they quoted me $900 & I also called a Tire & Auto Centers they quoted $1,000 & they tried to talk me out of it saying it will mess up my suspension .... really, then y do people still do it hahaha. I trust Toyota dealership than any other new establishment, but since when does lowering your car ever come out to $1,000 (I can save that money to do a paint job) ! Its usually $300-$600
Cheapest or inexpensive? Tanane makes decent products but any product in harsh conditions will not last. Ride wise, Tanabe springs will not sag over time like other brands.Originally Posted by Betrivent ↑With that size wheel, you can do almost anything to it to drop it. Cheapest option would probably be Tanabe NF210s. However, Tanabe springs do not last very long - they rust easily.
Or you can get some springs from Garm at Micro Image. He has some decently aggresive ones for under 200 I believe. HE has them made to order.
I would think any introduction of stiffer springs, struts, and/ or tire sidewalls would help to negate being pushed around on the road by wind. It will likely always feel that way with any car that is lightweight and has tall sides. My wife used to have a 2008 Beetle and it did it pretty bad too. And that was a heavier car than a Yaris..Originally Posted by Neurotic Hapi Snak ↑Would lowering my car help with body lift? At highway speeds, I can just feel the body lift up off the springs. With the boxy body and light weight, gusts of wind on the highway cause horrible body sway. At low speeds, the stock springs don't handle half bad, I just hate the sway at high speeds. And don't laugh, but a trailer hitch stiffens up the rear of the body.
Picture not included in this copyOriginally Posted by Mz3oh5 ↑I was going with Tein because they are springs that provide the maximum lowering height. The lower I can get the better the car it will look. My car looks cute from a far, but once you get close you see that the car needs to be lowered. It pisses me off everytime I look at it. lol