Yarisworld Archive

1NZ-FE Block Housing Thickness (Oil Pan Sub Assembly)

8 posts · 8,898 views

fnkngrvOriginal postIn The Hotbox · May 7, 2012#1
To give you perspective of what you are working with when tapping the block housing for any type of fitting.

Picture not included in this copy

Replies 7

cali yarisCanoga Park, CA · May 8, 2012#2
Is that hunk from the side of the block? yeah, that's THIN
eTiMaGoBangkok, Thailand · May 8, 2012#3
gotta keep it lightweight somehow!
fnkngrvThread starterIn The Hotbox · May 8, 2012#4
Originally Posted by cali yaris ↑
Is that hunk from the side of the block? yeah, that's THIN
yes. the place where the two pennies is sitting is where the fitting had been.
cali yarisCanoga Park, CA · May 8, 2012#5
Which also demonstrates the need for a fitting with a retainer washer/nut on the inside.
fnkngrvThread starterIn The Hotbox · May 8, 2012#6
Unfortunately yes. I spoke with two welders here that are considered very good to excellent with welding aluminum. Neither would touch my motor. They both would have tack welded a plate to the outside of the assembly to reinforce and "thicken" the mounting point however with the lack of thickness in the first place as well as the ridges in the assembly they didn't feel confident that it was a proper solution therefore the sandwich type fitting is the only route that I have at least.
Focus_Sh1ftNew Jersey · May 8, 2012#7
Originally Posted by cali yaris ↑
Which also demonstrates the need for a fitting with a retainer washer/nut on the inside.
+1

When I tapped the block for the return I remember getting comfy thinking I was going to be there for awhile. I was through it 5 seconds later 😆
SchizopreniaSurabaya, Indonesia · May 9, 2012#8
now that's funny. lets see how long i'd spend at the mechanic this weekend.

but the hard parts is removing the right side front axle no ?