Yarisworld Archive

check engine code P0101

7 posts · 12,787 views

bugg_masterOriginal postFresno, CA · Feb 4, 2012#1
hey u guys i recently upgraded my intake to an injen intake and a week later my check engine light came on...i rechecked the gas top to make sure it was closed tightly and today i just ran the test on it with the OCB2 the code that popped up was P0101 and P0171....i double checked the hoses that connects to the intake to make sure it was tightened but the lights still on. anybody have any idea about whats going on??? i really dont want to take it to toyota if its something i could do it myself. Thanks for reading and you opinions/suggestions! 👍

Replies 6

bugg_masterThread starterFresno, CA · Feb 4, 2012#2
noooooo i shouldve put this under the maintenance/service thread....y didnt i see that!!!!! :(
fnkngrvIn The Hotbox · Feb 5, 2012#3
0101 is usually a vacuum leak of some sort or the MAF. Could be that the MAF is sitting too low or too high or is it possible that you put it back on during installation backwards? Did you clear the codes to see how long before it came back?
bugg_masterThread starterFresno, CA · Feb 5, 2012#4
Originally Posted by fnkngrv ↑
0101 is usually a vacuum leak of some sort or the MAF. Could be that the MAF is sitting too low or too high or is it possible that you put it back on during installation backwards? Did you clear the codes to see how long before it came back?
i looked online to see how to reset the check engine light but the online thing that mainly showed online was reseting the maintenance light. i also tried taking out the fuse but its still showing....i screwed on the maf in all the way but i havent tried rotating it...i'll turn it around tomorrow and well see if the lights still there. but how could the maf be either too high or too low?
fnkngrvIn The Hotbox · Feb 5, 2012#5
it all depends on the mounting point on the intake piping. There was an issue with the AFE intake in regards this and it also came with spacers. As for resetting the code you can always disconnect the battery for 10-20 minutes.
KSIbuckyFond du Lac, WI · Feb 5, 2012#6
the MAF has to be put in the right direction and it clicks in.
CJDA9New Hampshire · Sep 24, 2016#7
Hey sorry to revive an old thread but I am having the same problem and codes showing up with my car after installing a short ram intake recently. wondering if anyone has found a fix.