hi im dont speak very well English lol so im going to try. im from Puerto Rico and want to make my Yaris HB turbo I know many people asked about this issue and there is much information here but my laptop is dead so im using my phone to read and its hard to search lol. i want to put only 5 or 6 psi no more because its my only car and i still paying the car. i want to know what else I need i have this items:
1. Hybrid Turbo Charger:
.57 compressor wheel trim mapped for low and high boost setups
Oil fitting gaskets & mounting studs included
Wet float bearings & properly balanced
3" inlet diameter with a 2" outlet
50 A/R compressor housing
.63 A/R turbine housing
1/8 NPT oil inlet
T3/T4 hybrid
2. intercooler
3. Piping Kit
4. Boost Controller
5. Electronic Turbo Timer
6. Heat Wrap
7. Downpipe "but i dont know if its going to fit very well"
8. Intake Filter
9. manifold
10. boost, oil temp gauge
11. Oil Feed Line
12. blow off
like i said just for 5 to 6 psi want to make some noise i dont want to repair my motor so fast 😆 any advice would be Thanked
1. Hybrid Turbo Charger:
.57 compressor wheel trim mapped for low and high boost setups
Oil fitting gaskets & mounting studs included
Wet float bearings & properly balanced
3" inlet diameter with a 2" outlet
50 A/R compressor housing
.63 A/R turbine housing
1/8 NPT oil inlet
T3/T4 hybrid
2. intercooler
3. Piping Kit
4. Boost Controller
5. Electronic Turbo Timer
6. Heat Wrap
7. Downpipe "but i dont know if its going to fit very well"
8. Intake Filter
9. manifold
10. boost, oil temp gauge
11. Oil Feed Line
12. blow off
like i said just for 5 to 6 psi want to make some noise i dont want to repair my motor so fast 😆 any advice would be Thanked