I recently purchased some Tanabe Coilovers from Micro Image. Here is my review.
Stock Suspension
Picture not included in this copy
Tein S-Tech Springs
Picture not included in this copy
Tanabe Coilovers
Picture not included in this copy
Picture not included in this copy
Picture not included in this copy
The goodies:
Picture not included in this copy
Installing them:
Picture not included in this copy
Ran into a problem with installing the fronts... ruined the top bolt in the stock strut/shock.
Picture not included in this copy
Front setup:
Picture not included in this copy
Rears:
This was the incorrect way of installing the rear. The collar just wobbles on the spring plate.
Picture not included in this copy
This is the correct way! :)
Picture not included in this copy
Super slammed on way back to my home after vacation, had over 250 extra pounds in it, scraped the WHOLE way.
Picture not included in this copy
Had a little visitor:
Picture not included in this copy
Working hard.
Picture not included in this copy
Halloween Photoshoot
Picture not included in this copy
My yaris and the Installer's(brother's) 240sx :)
Picture not included in this copy
Overall I would say Im happy with them. I wish they went a little lower. Im almost maxed out I have the one ring on the rear and fronts. I cut the bump stops on the fronts.
I havnt taken out the helper springs yet or taken out the adjuster ring... I only took out the lock rings.
They arnt super hard... They could be a bit stiffer as the fronts scrape on the plastic liners and edge of the wells. otherwise a super smoothe ride! Def. reccomend these if your looking for adjustability, ride comfort, and that low look! 👍
Thanks Garm!
Stock Suspension
Picture not included in this copy
Tein S-Tech Springs
Picture not included in this copy
Tanabe Coilovers
Picture not included in this copy
Picture not included in this copy
Picture not included in this copy
The goodies:
Picture not included in this copy
Installing them:
Picture not included in this copy
Ran into a problem with installing the fronts... ruined the top bolt in the stock strut/shock.
Picture not included in this copy
Front setup:
Picture not included in this copy
Rears:
This was the incorrect way of installing the rear. The collar just wobbles on the spring plate.
Picture not included in this copy
This is the correct way! :)
Picture not included in this copy
Super slammed on way back to my home after vacation, had over 250 extra pounds in it, scraped the WHOLE way.
Picture not included in this copy
Had a little visitor:
Picture not included in this copy
Working hard.
Picture not included in this copy
Halloween Photoshoot
Picture not included in this copy
My yaris and the Installer's(brother's) 240sx :)
Picture not included in this copy
Overall I would say Im happy with them. I wish they went a little lower. Im almost maxed out I have the one ring on the rear and fronts. I cut the bump stops on the fronts.
I havnt taken out the helper springs yet or taken out the adjuster ring... I only took out the lock rings.
They arnt super hard... They could be a bit stiffer as the fronts scrape on the plastic liners and edge of the wells. otherwise a super smoothe ride! Def. reccomend these if your looking for adjustability, ride comfort, and that low look! 👍
Thanks Garm!
14 attachments not included in this copy