does somebody install this kind of alarm ?
is it really plug and play with simple connector to plug and ready to use ?
thank you
is it really plug and play with simple connector to plug and ready to use ?
thank you
10 posts · 12,100 views
The CAN bus is accessible at the OBD port. The violet wire in pin 6 is CANH and the white wire in pin 14 is CANL.Originally Posted by henry33 ↑scott do you know where the canbus is located in Yari
It's actually very hard to mess it up with the robustness of the communication protocol. When you do (as I once did with a flakey transceiver IC), the ECM goes into limp mode and your warning lights make the cluster look like a christmas tree.Originally Posted by BLH ↑Just be real careful.
The CAN buss runs data between many of the electronic control modules in the car.
Mess it up and who knows what will happen.
http://www.etimago.com/yaris/repairmanual/CAN.pdf
CAN is amazingly robust. Most CAN transceivers are fault protected to +/- 80 Volts. As with any communication bus, it is very possible to shut down communications by pulling it down or flooding it with traffic, but in the case of a vehicle like the Yaris, the CAN bus is not used for engine control, but rather to let the ECM get or share data with the other systems.Originally Posted by BLH ↑Thanks for the information.
As an electronic technician. I have seen some busses get smashed big time.