Yarisworld Archive

Cannot figure out how to remove tail lights!

13 posts · 16,259 views

bL@cKy@Ri$1Original postOrlando, Fl · Mar 26, 2011#1
So I am trying to install hellastyle tail lights on my sedan and I tried and tried to remove the tail lights but I couldn't figure it out! I removed the two 10mm bolts and tried to pull em out but wouldnt happen! Is there anything I'm missing?

Replies 12

ilikericesavannah, ga · Mar 26, 2011#2
3 bolts. there are 2 along the outside and then 1 more more toward the center of the car. looking at my old ones now
bL@cKy@Ri$1Thread starterOrlando, Fl · Mar 26, 2011#3
Thanks let me know what you find!
bL@cKy@Ri$1Thread starterOrlando, Fl · Mar 26, 2011#4
But I think the sedan and hatch are different.
CTScottUSA, CT · Mar 26, 2011#5
Originally Posted by bL@cKy@Ri$1 ↑
But I think the sedan and hatch are different.
If you look at page LI-123 of the lighting section of the service manual, for the sedan it says to remove the two nuts, pull the connector, and then slide the light assembly towards the rear to remove it. If it is hard to remove, the gasket may be sticking.
bL@cKy@Ri$1Thread starterOrlando, Fl · Mar 26, 2011#6
Thanks! I'll look through the manual tomorrow! Hopefully I get them out!
JumpmanYarisSO. INDIANA · Mar 26, 2011#7
if you need pics let me know it has 3 bolts and a plastic clip holding to the sides of the taillights which you have to reuse for the aftermarket ones
bL@cKy@Ri$1Thread starterOrlando, Fl · Mar 27, 2011#8
Pics would definitely be helpful and appreciated Jumpman!
JumpmanYarisSO. INDIANA · Mar 27, 2011#9
Pmd hit me up if u can 787 432 0065,
JumpmanYarisSO. INDIANA · Mar 27, 2011#10
Nothing yet?
goliath1812Ocala Florida · May 4, 2011#11
Well I am having the same problem. I removed the 2 nuts, disconnected the bulb, the light assembly just wont come out....were you ever able to get any pics Jumpman?
BrianRiverside, CA · May 4, 2011#12
They're hard to remove for the first time. Wiggle them from side to side while pulling back on them. They will come out eventually.
KevDWinnipeg, Canada (eh!) · May 5, 2011#13
I did this today on my 3dr. Probably pretty similar. Yeah, two 10mm nuts for mine. Then there's a plastic clip. I just put my hand in the access hole (from the trunk) and pushed outward on the assembly while pulling from the outside with my other hand. Eventually it loosened up and then POP! Out it came..

Be patient. You'll get it!