Yarisworld Archive

replace alternator 2007 yaris

10 posts · 17,797 views

rnicholsOriginal post61 · Feb 26, 2011#1
how do you replace the alternator on 2007 yaris

Replies 9

rnicholsThread starter61 · Feb 26, 2011#2
how do you replace the alternator on 2007 yaris
swiddCentral Alabama, GOD BLESS AMERICA · Feb 26, 2011#4
It mentions removing a right side engine under cover. Is this to perform the job from underneath the vehicle, on a lift? Can it also be performed by removing the front bumper? Or do you HAVE to remove the front bumper anyway? Or can it be done from the top?
The ArchitectFL · Feb 26, 2011#5
It can be done from the top without removing the front bumper, I know because I've done it and Ive also had to put on a serpentine belt on the side of the highway, fun stuff.
Klink10910 · Feb 27, 2011#6
As stated check out the stickied service manual and get familiar with that section. Understand how the wiring clips to the alt. so you don't break those. Be sure to understand where to apply force when tightening up the belt after replacement. That said I can have one off in 15 minutes from the hood opening.
CTScottUSA, CT · Feb 27, 2011#7
^+1

Those are good points. Make very sure that you disconnect the battery before pulling the alternator wiring. The large gauge wire is directly connected to the battery with a larger fuse than you want to experience popping.

Also, as mentioned you have to be very careful not to pry against the camshaft timing oil control valve.
yakchezzetcook · Dec 10, 2020#8
G'day I know this is an old post but, the 14 mm bolt is extremely difficult to access from the top...what do you suggest for tools ??
I'm using 3/8 ratchet w/14mm six point socket but there isn't enough engagement for the ratchet to socket; it hits the idler pulley, no room for a regular extension
ps I have removed the A/C line bracket as noted in the service manual
cheers & thanx
yak
WeeYariGeorgetown, Ontario, Canada · Dec 10, 2020#9
Originally Posted by yak ↑
G'day I know this is an old post but, the 14 mm bolt is extremely difficult to access from the top...what do you suggest for tools ??
I'm using 3/8 ratchet w/14mm six point socket but there isn't enough engagement for the ratchet to socket; it hits the idler pulley, no room for a regular extension
ps I have removed the A/C line bracket as noted in the service manual
cheers & thanx
yak
You must have a fatter head on your socket driver than I do. Mine, tight but doable.
IMG_20201210_142744.jpg
06YarisRSFredericton, New Brunswick, Canada · Dec 10, 2020#10
Have a ratchet wrench?