This procedure is directly from the toyota repair manual for the Yaris Liftback...I got the manual from here: http://www.etimago.com/yaris/repairmanual/Exterior.pdf
okay here we go - this is quite funny.
step 1: set the parking brake and block the rear wheels. raise the front of the vehicle, and put it on jackstands

step 2:
remove the 5 plastic clips at the top of the bumper cover,
1 from each wheel well, and the 8 bolts from the bottom fascia. I like to organize the bolts in a block of wood, oriented from left to right.

Step 3:
disengage the 3 clips on each side, holding the bumper to the fender. tilt the bumper cover forward.

step 4:
unclip the wire connectors for the fog lights( if equipped), and also the block heater cord (if equipped)

step 5:
remove the bumper cover.

step 6:
locate and remove 3 10mm bolts holding the headlight in place. remove the headlight.

step 7:
remove the old bulb and dust boot, taking care not to tear the boot.

step 8:
re-install the new headlight bulb and connect the wires.

step 9:
test that bulb works, after all that effin work you did.


step 10:
the headlight assembly is now ready to be re-installed.
locate the 3 10mm bolts you removed, and put them in. it is impossible to affect the headlight aiming.

step 11:
"installation is reverse of removal."
-re-attach the foglight connectors
-re-install 7 plastic clips
-re-engage 6 plastic clips to the fenders
-re-install 8 bolts from under the front fascia

step 12:
if equipped, cable tie block heater back to grille.

step 13:
remove the jackstands, and lower the vehicle

step 14:
let the happy car smile!

okay here we go - this is quite funny.
step 1: set the parking brake and block the rear wheels. raise the front of the vehicle, and put it on jackstands

step 2:
remove the 5 plastic clips at the top of the bumper cover,
1 from each wheel well, and the 8 bolts from the bottom fascia. I like to organize the bolts in a block of wood, oriented from left to right.

Step 3:
disengage the 3 clips on each side, holding the bumper to the fender. tilt the bumper cover forward.

step 4:
unclip the wire connectors for the fog lights( if equipped), and also the block heater cord (if equipped)

step 5:
remove the bumper cover.

step 6:
locate and remove 3 10mm bolts holding the headlight in place. remove the headlight.

step 7:
remove the old bulb and dust boot, taking care not to tear the boot.

step 8:
re-install the new headlight bulb and connect the wires.

step 9:
test that bulb works, after all that effin work you did.


step 10:
the headlight assembly is now ready to be re-installed.
locate the 3 10mm bolts you removed, and put them in. it is impossible to affect the headlight aiming.

step 11:
"installation is reverse of removal."
-re-attach the foglight connectors
-re-install 7 plastic clips
-re-engage 6 plastic clips to the fenders
-re-install 8 bolts from under the front fascia

step 12:
if equipped, cable tie block heater back to grille.

step 13:
remove the jackstands, and lower the vehicle

step 14:
let the happy car smile!
