Yarisworld Archive

So, I'm going to drill some holes in my roof...

65 posts · 30,408 views · page 2 of 2

Replies continued

dingbatMid-Turn (probably late apexing) · Sep 16, 2010#51
When I looked into it for my lift-back, Toyota's instructions for removing the headliner properly requires removing almost all of the interior trim, starting with the seats.

Good luck.
NebarnixMesa, AZ · Sep 16, 2010#52
Originally Posted by dingbat ↑
When I looked into it for my lift-back, Toyota's instructions for removing the headliner properly requires removing almost all of the interior trim, starting with the seats.

Good luck.
Did the other's in the forum have to remove the seats? That sounds.. really terrible... sigh.
colpumpkinnutsThread starterMass · Sep 17, 2010#53
I looked at the same thing as dingbat and decided it wasn't worth it. If you look at the interior of your car you'll notice that it looks like it was assembled from the roof down. Meaning you'll have to disassemble from the floor up. I'm not sure you'll have to take out the seats but it will definitely require the removal of a lot of trim pieces.
colpumpkinnutsThread starterMass · Sep 17, 2010#54
So, I finally got a boat and snapped some pics. I took it out for a spin yesterday. The car handles the load pretty well doesn't complain too much until I get above 60mph. Loading the boat onto the low roof is surprisingly easy.

In this photo I've got the boat a bit farther back than I normally would so it doesn't overhang quite so much.
DHM_100916_0001_email.jpg
JonSTacoma, WA · Sep 17, 2010#55
Sweet!!!
dingbatMid-Turn (probably late apexing) · Sep 23, 2010#56
Originally Posted by Nebarnix ↑
Did the other's in the forum have to remove the seats? That sounds.. really terrible... sigh.
Blind faith 😉

I just studied CTScott's pics, gently pushed up on the headliner with my hands to feel for the location of the cross braces, and drilled away.🤘

Please be aware, I almost screwed the pooch on the rear-most hole though.😲

You can read all about it in this post.

Good luck.
mytLaurel, MD · Oct 3, 2010#57
I know it has been a while, but after breaking 3 more of the nuts I finally finished my install! I will post pics next time I go out with the yak... All in all it wasn't too bad. But anyone going with the Yakima landing pads...beware not to tighten the bolts too tight! Otherwise the nuts will break on you...

MYT
mytLaurel, MD · Oct 23, 2010#58
I know its been a while...but here is my install! Finally...lol!

Picture lost · i238.photobucket.com

MYT
birdmanUSA · Oct 24, 2010#59
Why doesn't Toyota offer this as a dealer installed option? Go figure. Nice install.
why?harnett county NC · Oct 24, 2010#60
okay so I first looked at that picture and wondered,"what install?" Man am I blind. Only thing I would be afraid of is that kayak acting like a sail.
mytLaurel, MD · Oct 25, 2010#61
Birdman, I wish they would too! I would have jumped on it for sure! I guess they figure that economist minded drivers wouldn't put anything on the roof :(

Why, I haven't felt any more wind influence on the car than without it. And I push it too... 70MPH or so... But then again, I don't really take the yak out if its too windy so in high winds it won't be strapped down! Sorry the pic doesn't really show the install I guess, just the end result. I will try to get some good pics of just the bases.

MYT
why?harnett county NC · Oct 26, 2010#62
Originally Posted by myt ↑
Birdman, I wish they would too! I would have jumped on it for sure! I guess they figure that economist minded drivers wouldn't put anything on the roof :(

Why, I haven't felt any more wind influence on the car than without it. And I push it too... 70MPH or so... But then again, I don't really take the yak out if its too windy so in high winds it won't be strapped down! Sorry the pic doesn't really show the install I guess, just the end result. I will try to get some good pics of just the bases.

MYT
lol no i mean at first glance i did not even see the kayak.
mytLaurel, MD · Oct 26, 2010#63
LMAO thats the first I've heard that one! ;)

MYT
why?harnett county NC · Oct 27, 2010#64
yup, I'm practically blind.
cabinfevrrLunenberg County, Nova Scotia · Nov 15, 2010#65
those racks look great. next spring i'm going to upgrade my rack. Like a stooge, I bought the OEM rack. what a piece of crap. with our two Necky Manitou 14 kayaks we're overloading the rack by about 2 pounds. also the rack has tons of wind noise, and are quite flimsy.