no, on the Yaris it is programmed by miles driven. no other factors afaikOriginally Posted by 2007tRD ↑close to 5000miles...not exactly 5000.
Killer oil!
57 posts · 21,527 views · page 2 of 2
Replies continued
to detect a headgasket leak, you do a compression test on theOriginally Posted by Hershey ↑If it's a very fine internal leak most moisture probably would get burned off ( evaporate ) . So , could take a long time for it to accumulate internally . The only thing to most likely detect it early would be with a U.O.A. ( Used Oil Analysis ) . We may have to go that route .
cylinders and a pressure test on the cooling system.
and use a block tester on the coolant to detect exhaust gasses
uoa is overkill, don't need one
some sources say to replace the pcv valve along with your spark plugs at their intervals.The service manual says no such thing though.Originally Posted by Hershey ↑So , 2007tRD you're suggesting that I / we should check or possibly replace the PCV as early as 20,000+ miles ? They're not all that expensive ( < $ 7.00 ) at a TOYO parts department . Think the part number for the '08 sedan which was manufactured in APRIL of '08 is 12204-12011 . Here's a thread for the correct PCV valve for your YARIS , Two different PCV valve Part#s for Yaris? . Appreciate all your help . 👍
read your owners/service manual...I just looked over mine, and it says it comes on "about" 4500 miles from the last reset.Originally Posted by 127.0.0.1 ↑no, on the Yaris it is programmed by miles driven. no other factors afaik
Originally Posted by sleey0 ↑Toyo is going 0W-20 synthetic for the 2010's.
My 2010 states in the manuel and on the oil fill cap....5w-30.Factory oil is not going to "cure" gaskets,the gasket,is as it is! no curing needed.If this was a conversation YEARS ago and a person used the old permatex form a gasket,then, yes there would be a curing time table.Synthetic oil has much better "flow" characteristics than dino...it will "find" weak points in old gaskets and funky set points in new gaskets.
Originally Posted by 2007tRD ↑You are absolutely correct about starting on synthetic too early,the engine requires the factory filled high detergent oil for break-in.I extensively reserched the sluge issue,and every source points back to my first post,...change your oil every time the maintenance minder light comes on.pay no attention to what anyone says regaurding changing your oil at 3000 or 5000 miles,as those are just industry standards...not Toyotas.the maintenance minder system caculates every variable possible[idle time,miles driven,engine loads,average speed]and decides by that data when you should change the oil.sludge is caused by water in the oil,it gets in there via condensation everytime you engine is shut down and the oil temp drops below 212 degrees farenheit.the longer the same oil is used the more water accumulates,this is while oil shoud be changed once a year even if the engine is never started.
I believe synthetic oil has better "cleaning" characteristics than dino!...and,modern multi grade oils are detergent!.😁
Just change your oil and filter.
Ah good point! Best of luck, would love to get to the bottom of this... Makes me a little wary of the old lady's car.. 😲Originally Posted by Hershey ↑If it's a very fine internal leak most moisture probably would get burned off ( evaporate ) . So , could take a long time for it to accumulate internally . The only thing to most likely detect it early would be with a U.O.A. ( Used Oil Analysis ) . We may have to go that route .