ebby2222Original postPerth Australia · Jul 7, 2010#1Just bought a 2008 Yarris Rush (38K on clock).
Experiencing problems when changing up into gear (manual). The throttle doesnt "come off quick enough/not responsive enough.
Is this a generic problem with the drive by wire system as opposed to a throttle cable?
Regards
Pete
Perth Australia
Replies 7
Yaris HiltonBristol, Tennessee, USA · Jul 7, 2010#2Yep. Many threads on this board have discussed the issue. It's just the way it's programmed.
ebby2222Thread starterPerth Australia · Jul 7, 2010#3Thanks for your prompt response.
UIs there a solution? Can I take it into a dealer & get it reprogramed?
Regards
Peter
SAV912Savannah, GA · Jul 7, 2010#4 Originally Posted by
ebby2222 ↑ Thanks for your prompt response.
UIs there a solution? Can I take it into a dealer & get it reprogramed?
Regards
Peter
The dealer will tell you that's how it is and then basically to pound sand. The rev-hang is there in DBW MT cars to help emissions.
You can however have it reprogrammed aftermarket. It's usually done with a tune after intake/exhaust mods, but I'm sure can be done standalone.
-SAV🍻
Yaris HiltonBristol, Tennessee, USA · Jul 7, 2010#5I don't believe any of the aftermarket folks have figured out how to retune the Toyota ECU, actually. There are some hang-on mods that alter input from sensors to it.
RyudeLouisiana · Jul 7, 2010#6Hydra EMS, AEM EMS, etc will let you tune it but the cost of doing so is significant.
IllusionXBrossard, QC · Jul 8, 2010#7If you keep on revving UP as you press on the clutch.. consider letting go the throttle before pressing the clutch...
i mean, it's really a timing issue..
RyudeLouisiana · Jul 8, 2010#8My mustang gt has dbw and before the custom tune it did the same thing. After tune my mpg went up 2-3 mpg, and that's with a v8!