Focus_Sh1ftOriginal postNew Jersey · Apr 14, 2010#1Replies 8
minnyarMinneapolis · Apr 14, 2010#2I have had the discount intake before and have never had a problem. I plan on doing the same intake, but with a higher quality filter.
The header I am skeptical of. The stock Yaris exhaust isn't that bad, and a header is so easy to screw up I would steer clear. I don't have it, (yet:)) but the NST pulley set would be the way to go for a little more power, and would be less risky than the header.
Good luck!
MouseMiami, Fl. · Apr 14, 2010#3I got the Bomz CAI replaced the cheap filter it came with for an AEM Dryflow and wrapped the intake with heat reflective film. I think the quality of the intake pipe is good for the 60 dollars I spent on it.
thebarberGrand Rapids, MI · Apr 14, 2010#4forget the header
bomz cai would be fine, just replace the filter w/ an aem or k&n
Focus_Sh1ftThread starterNew Jersey · Apr 14, 2010#5Bought the CAI, I'll definitely put a higher flow filter on it at some point. Do you guys think a header is even worth it? Or is the stock not that much worse than say a Megan or DC header?
thebarberGrand Rapids, MI · Apr 15, 2010#6i just put a DC header on my yaris on sunday....very nice gains
i waited to grab a DC used....ive seen the junk some other brands make and i wanted to wait for the best.
you get what you pay for.
cali yarisCanoga Park, CA · Apr 15, 2010#7 you get what you pay for.
+10000000000 and that includes SERVICE if there is an after-sale problem!
cali yarisCanoga Park, CA · Apr 15, 2010#8 nd a header is so easy to screw up I would steer clear. I don't have it, (yet:)) but the NST pulley set would be the way to go for a little more power, and would be less risky than the header.
how do you figure that? The crank bolt is a critical engine component, if you don't get that right, no car.
yarrrnew mexico · Apr 15, 2010#9 Originally Posted by
cali yaris ↑ how do you figure that? The crank bolt is a critical engine component, if you don't get that right, no car.
Yup, doing pulleys you run the risk of breaking the vvti solenoid, header you run the risk of breaking the 02 sensor. Of course you could always snap your MAF trying to pull it out of your stock intake... Thing is all 3 of those breakable parts will cost you more than what you were replacing... lol
Or you could just install things correctly(read: not like a gorilla) and there's no risk of anything...