msfire671Original post671 · Feb 26, 2010#1hey fellas...
i just placed an order for some lowering springs and other goodies from Garm, my brother thinks its a bad idea because it could mess up the tranny..has anyone ever encountered a problem with their suspension or trans? im just a lilttle hesitant if it could cause some problems...any suggestions for the noob? lol..it would be greatly appreciated.
thanks!
Replies 9
WeeYariGeorgetown, Ontario, Canada · Feb 26, 2010#2Your brother on crack? lol
hatchbackkid82. · Feb 26, 2010#3I heard of something like that on another forum. The guy lowered his car and trans went out shortly after. He replaced the trans, and that one went out. He replaced it two more times afterwards with the same result. He took it to a mechanic and the mechanic said it was b/c it was too low and something about the axle angle. This was on a CRX
You should be ok though, i've lowered every car i had and never had a trans go out on me.
msfire671Thread starter671 · Feb 26, 2010#4ahhh..i see. well thanks for the reply guys.
cali yarisCanoga Park, CA · Feb 26, 2010#5Never heard of a single problem with springs and the Yaris.
heeroyuy01195Florida · Feb 26, 2010#6that usually only happens if you slam the car to the ground incorrectly, if you just bought lowering springs, most are around 2" drop max so you'll be fine.
ozmddDFW, TX · Feb 26, 2010#7+1
The kind of drops you get with these sorings will not hurt your tranny at all. That only happens when people cut springs drastically and put strain on the driveshafts where they weren't meant to have it.
What these springs do is lower the center of gravity, but the forces on the axles are identical to oem suspension. You'll be fine, and your brother will be jealous.
127.0.0.1NE · Feb 26, 2010#8the worst it can do, if installed correctly, is create excessive wear on the CV's
from the 'non-standard' angle of the propeller. 1 inch in these little CV's are ok,
but 2 inches would wear them out faster (YMMV)... but tranny problems ? I doubt the actual
transmission is affected
DerFlosserUSA · Feb 26, 2010#9 Originally Posted by
127.0.0.1 ↑ the worst it can do, if installed correctly, is create excessive wear on the CV's
from the 'non-standard' angle of the propeller. 1 inch in these little CV's are ok,
but 2 inches would wear them out faster (YMMV)... but tranny problems ? I doubt the actual
transmission is affected
correct....
msfire671Thread starter671 · Feb 26, 2010#10i am so relieved! lol...thanks guys!